This is the Novak Eiger 2S/3S Brushed Electronic Speed Control
and the Rockstar 45 Turn Brushed Motor for Crawling Applications.
FEATURES: ESC (NOVM1835);
Compatible with all Novak brushed motors including the Terra Claw and
Rock Star motors
Compatible with 2-3S LiPo cells and 4-9 cell NiMH batteries
Heavy duty 2-amp BEC
Three throttle modes;
Rock Crawl Mode with adjustable drag brake power
Standard/Basher Mode for normal FWD/BRK/REV
Robotic or Servo Mode for FWD/REV operation only
Four adjustable parameters;
Brake Power/Throttle Mode (5 settings)
Dead Band (5 settings)
Drive Frequency (5 settings)
Voltage Cut-Off
One-Touch programming interface with four multi-colored status LEDs
6V output for cooling fan or other options such as running lights
Temperature monitoring allows user to check ESC operating temperature
at any time
Thermal overload protection to prevent overheating
Water-resistant case with silicone gasket seal
One touch setup
RoHS compliant
Motor (NOVC3547);
Designed for crawler vehicles that require precise movement control
High number of turns for excellent torque and long run times
Rebuildable with easily accessible commutator and replaceable
brushes and springs
Stand-up brush design
High-strength ferrite magnet
Dual ball bearings
Direct solder wiring tabs for flexible soldering options
120 day limited warranty on both components through Novak
INCLUDES: Novak Eiger Brushed ESC with Tamiya Type Battery Connector, Gold
Plated Bullet Motor Plugs, Mounting Tape, Power Cap, Wires, Heat
Sink, Rock Star 45 Turn Brushed Motor and Instruction Manual
REQUIRES: Pinion gear of modeler's choice
Installing in vehicle and connecting to battery and receiver
SPECS: ESC;
Motor Compatibility: 380, 540 size brushed
Input Cells: 2-3S LiPo or 4-9 NiMH
Size: 1.15 x 0.95 x 0.66" (29.0 x 24.3 x 16.8mm)
Weight: 0.64oz. (18.1g) without wires
On-Resistance: 0.0013 ohms
Motor Limit: 20T or higher (2S); 35T or higher (3S) brushed
540 motor, and any 380 size brushed motor
BEC: 6V DC/2A
Wire Size: 14G Super-Flex Copper-Strand Silicone Wire
Motor;
Motor Size: 2.07 x 1.42" (52.7 x 36.1mm)
Shaft Diameter: 0.125" (3.2mm) accepts all 1/8" pinion gears
Bearing: Standard 3/8" x 1/8"
Motor Weight: 5.97oz. (169g)
jxs 02/23/12
ir/jxs
| 
