This is the Radio Controlled, Glow Powered, Balsa and Plywood
House of Balsa Chea-Pass Float Plane .10 Airplane Kit.
This kit consists of pre-cut wood only, all items such as
the engine mount, connectors, linkages, and
assembly hardware must be purchased separately.
For Intermediate to Advanced Modeler/Flyers.
FEATURES: Easy interlocking balsa and plywood construction, with built-in
thrust angles and a wing that assembles flat on die-cut ribs.
Wings are one-piece, all wood designed for single aileron servo
Spacious radio compartment allows easy radio gear installation and
quick fuel tank access.
INCLUDES: One House of Balsa Chea-Pass Float Plane .10 Airplane Kit with all
balsa and plywood to construct the airplane, glass tape to join
wing halves, wood dowels, instruction sheet, two steel wires and
two brass tubes for aileron linkage.
REQUIRES: Engine: .09-.12 (1.5-2.0cc) (2-stroke)
Radio: 4 channel
Servos: 4 micro servos (1-throttle, 1-aileron, 1-rudder, 1-elevator)
Misc. Items: 1-1/2" spinner, 2-3oz fuel tank, 1/4" foam rubber
padding, fuel tubing, fuel filter, propeller, CA glue, engine mount
and blind nuts, control horns, hinges, throttle cable, covering,
aileron hinges and building and field equipment.
SPECS: Wingspan: 45.5" (1156mm)
Wing Area: 318 sq in (20.51 sq dm)
Weight: 2 lb (907.2 kg)
Wing Loading: 14.5 oz/sq ft (44.24 g/sq dm)
Length: 31" (787mm)
Airfoil: Semi-Symmetrical (High Wing)
Center of Gravity: 1-3/4" (44mm) Back from the wing's leading edge
at the fuselage sides.
Ailerons: up-3/16" (4.5mm) down-1/8" (3mm)
Elevator: up & down 3/8" (19mm)
Rudder: right & left 5/8" (11mm)