This is the electric powered, radio controlled
                       FunJet Ultra Kit from Multiplex.
                    For Intermediate to Advanced Modelers.

FEATURES: Construction: Elapor foam
          Wings: One-piece with 22.5" (571mm) x .25" (6.35mm) fiberglass spar
          Canopy: Removable for access to electronics
          Landing Gear: None, model should be hand launched and belly landed
          Control Surfaces: Aileron and elevator (delta mixer required)
          Hardware: Pushrods, hook and loop material, screw lock connectors,
            and other miscellaneous hardware inlcuded
          Motor Mount: Black plastic construction

INCLUDES: FunJet Ultra Kit with Decals, Wing Spar, Motor Mount and Instruction
            Manual

REQUIRES: Radio: At least 3-channel with elevon mixing
          Servos: 2 micro size
          12" (305mm) Servo Extensions: Two
          Motor: Outrunner brushless, Multiplex makes a Power Pack that
            includes a brushless motor, ESC, propeller and motor mount
          LiPo Battery: 3S 2100-3200mah pack may require a
           mating connector (WSDM1302) to be soldered to the ESC battery leads
          LiPo Battery Charger: Compatible with selected battery
          Building and field equipment

SPECS:    Wingspan: 30.8" (783mm)
          Wing Area: 224.75 sq in (14.52 sq dm)
          Wing Loading: 19.7oz sq/ft (60.12g sq/dm)
          Fuselage Length: 29.5" (750mm)
          Configuration: Mid-wing
          Airfoil: Semi-symmetrical
          Weight: 31oz (875g)
          Control Throws-
            Elevator, Up: 10mm
                      Down: 8mm
            Aileron: +8 / -11mm (negative differential)
          Center of Gravity (CG): No numerical value given by manufacturer-
            Locate hemispherical markings on underside of wing near leading
            edge. Support model at this point with two fingertips and adjust
            position of flight battery to balance. Mark location of battery
            inside fuselage to ensure that it is always replaced in the same
            position.

COMMENTS: This model is NOT made of styrofoam and it is not possible to glue
            the material using white or epoxy glue. Medium CA glue used with
            an activator is the only method of gluing recommended by the
            manufacturer.

                                                                   jxs 08/31/10
                                                                         ir/jxs