This is the electric powered, radio controlled,
        Associated Factory Team 12R5.1 1/12 scale On-Road Pan Car Kit.
     Includes the #4690 (ASCC4690) LiPo Conversion Kit that consists of;
                 #4691 LiPo Chassis        #4695 Top Plate
                 #4692 Lower Pod Plate     #4696 Two Shock Mount Uprights
                 #4693 Upper Pod Plate     #4698 Hinge Pin Brace
                 #4694 Chassis Brace       #4699 Five Aluminum Standoffs

FEATURES: Chassis: 0.10" (2.5mm) thick woven carbon fiber with top plate,
            wide rear pod for easy installation of brushless motors and better
            heat dissipation, Factory Team pivot ball-link chassis allows for
            independent roll, bump and alignment adjustment, now optimized for
            use with 1S LiPo batteries for smoother mid-corner steering in
            high traction conditions
          Drive: Two wheel rear
          Ball Bearings: Full set included
          Differential: Ball type
          Motor Mount: Factory Team blue machined aluminum
          Shock: Factory Team shock with through-shaft design
            for equalized damping throughout the full stroke with no unwanted
            rebound, shock also controls chassis droop and adjusts with a
            turnbuckle wrench, woven carbon fiber center shock tower with four
            mounting positions
          Suspension: Pivot ball link rear suspension allowing independent
            adjustments for chassis roll, bump and alignment, active strut
            front end with symmetric components and adjustable caster and
            track width
          Bumper: Foam front
          Caster: Adjustable, caster/toe-in refers to the angle of the front
            suspension when viewed from the side of the car in relation to the
            chassis
          Camber: Adjustable, camber refers to the angle of the tops of the
            tires from vertical when viewed from front or behind vehicle
          Ackerman: Adjustable with spacers, Ackerman describes the effect of
            the inside front wheel turning faster than the outside front wheel
            during turns

INCLUDES: Associated Factory Team 12R5.1 Pan Car Kit with LiPo Conversion Kit
            Decals, 96T spur gear illustrated instruction manual

REQUIRES: Radio: 2-channel with mini steering servo
          Electronic Speed Control: For stock or modified motor
          Motor: 540 size
          Battery: 4-cell sub-C 2x2 flat configuration NiMH, or 1S LiPo pack
          Battery Charger: For selected battery
          Wheels and Tires: 1/12 scale on-road
          Pinion Gear: 61 pitch, number of teeth dependent on selected motor
          Body: 1/12 scale high downforce type
          Building and track equipment

SPECS:    Length: 10.4" (265mm)
          Width:   6.7" (170mm)
          Wheelbase: 7.7" (196mm)
          Weight: 29.3oz (830g)
          Internal Gear Ratio: 1:1

COMMENTS: For Replacement Ball Bearings use:
            Qty.    Size        Location               Qty   Bearing Set
             2     1/4x3x8"     Rear Axle               2     ASCC7600
             2     1/4x3x8"     Ride Height Adjuster    2     ASCC7600
             8     1/8x5/16"    Fr & Rear Wheels        4     ASCC4125

                                                                   jxs 02/21/12
                                                                         ir/jxs