This is the 1/8 scale, glow powered, radio controlled,
Hot Bodies off-road D8 Atsushi Hara Edition Buggy Kit.
FEATURES: Chassis: 0.12" (3mm) thick 7075 aluminum with engine repositioned
closer to center line for quicker steering and faster response
Drive: Four wheel shaft drive
Fuel Tank: 5.1oz (150cc) plastic with flip top cap
Air Filter: Foam low profile design
Clutch: 3 shoe, carbon construction
Clutch Bell: 16 tooth steel
Engine Mount: One-piece
Transmission: Single speed
Ball Bearings: Full set
Shocks: Oil-filled Big Bore, front 97mm, rear, 112mm, 68mm yellow
rear springs, 4mm diameter shafts, 500w silicone shock oil
Shock Towers: 0.20" (5mm) thick aluminum
Main Gear: 48 tooth lightweight steel
Gearboxes: Sealed
Differentials: Planetary gear
Brakes: Dual fiber discs
Wheels: White plastic dish wheels, 3.3" (85mm) diameter, 1.6" (42mm)
wide, 17mm hex
Body: Clear untrimmed polycarbonate buggy body
Bumpers: Front hardened plastic
Suspension: Front aluminum spindles, new rear aluminum hub with
horizontal captured pivot ball
Caster: Adjustable, caster/toe-in refers to the angle of the front
suspension when viewed from the side of the car in relation to the
chassis
Camber: Adjustable front and rear, camber refers to the angle of the
tops of the tires from vertical when viewed from front or behind
vehicle
Steering: Race optimized with servo saver, turnbuckles, steel drag
link and sway bar in one tight package
Warranty Period: Two year limited, valid only in the U.S. Canada, and
South America
INCLUDES: 1/8 scale Hot Bodies Atsushi Hara edition off-road Buggy Kit, foam
air filter, body, wheels, rear wing, clutch bell, spur gear,
instructions and decal sheet
REQUIRES: Radio: 2-Channel with 2 Servos (high torque servo for steering)
Radio Batteries: (8) AA size
Receiver Pack: 6V hump
Engine: .21 cu in (3.4cc) rear exhaust
Exhaust: Tuned pipe
Engine Starter: Hand-held type with rubber adapter for vehicle use
Tires: 1/8 scale off-road truggy
Glow Starter: 1.2 volt
Paint: Polycarbonate safe for body
Misc. Items: Fuel bottle, building and track equipment
Fuel: 2-cycle glow fuel with 10%-15% nitromethane, 16% lubricant-
Most of the fuels we carry meet or exceed the lubricant content
required for optimum performance and maximum engine life. In the
past, the conventional lubricant content used in fuel was 18%. But
with new advanced technologies, fuels like Red Alert and O'Donnell
for example, have a better quality of lubricants even though the
percentages of lubricant content are lower. These high-tech
lubricants provide exceptional cooling and protection.
SPECS: Vehicle-
Length: 19.7 (500mm) from front bumper to end of rear wing
Width: 12" (305mm)
Weight: 9lbs (4082g) approximately
Wheelbase: 12.9 - 13" (328 - 331mm) wheels on-center front-to-rear
Gear Ratio: 4.3:1
Weight: 7.5lbs (3.4kg) with racing gear
Body-
Length: 14.75" (375mm)
Width: 7.5" (190mm) at widest point
Height: 3" (76mm)
COMMENTS: For Replacement Ball Bearings use:
Qty. Size Location Qty. Bearing Set
2 6x10mm Steering 1 DTXC1561
6 8x16mm Diffs 3 DTXC1585
6 8x16mm Diff Cases 3 DTXC1585
2 5x11mm Clutch 1 DTXC1547
4 8x14mm Front Hubs 2 DTXC1583
4 8x14mm Rear Hubs 2 DTXC1583
jxs 11/16/10
ir/jxs
|