This is the glow powered, radio controlled 1/8 scale
                  On-Road MRX5 Race Car Kit from Mugen.

FEATURES: Chassis: 0.20" (5mm) thick natural finish aluminum
          Drive: Four wheel, three belt with 8mm tube shaft for gearbox,
            aluminum middle shaft
          Steering: Bellcrank with servo saver
          Suspension: Front and rear anti-roll bars
          Shocks: Oil-filled, aluminum body
          Clutch: Three shoe
          Bumper: Front, flexible plastic
          Transmission: Two-speed with 8mm hollow two speed shaft
          Brake: Integral with throttle
          Caster: Adjustable, caster/toe-in refers to the angle of the front
            suspension when viewed from the side of the car in relation to the
            chassis
          Camber: Adjustable, camber refers to the angle of the tops of the
            tires from vertical when viewed from front or behind vehicle
          Ackerman: Adjustable, Ackerman describes the effect of the inside
            front wheel turning faster than the outside front wheel during
            turns, new design alllows easy Ackerman change

INCLUDES: On-Road MRX5 Race Car Kit with Shocks, Shock Oil, Decals, Fuel Tank
            and instructions

REQUIRES: Radio: 2-channel with high speed steering servo
          Engine: .21 cu in (3.4cc) rear exhaust, non-pull start
          Exhaust: Tuned pipe with header
          Fuel: Car blend 10-30% nitro content w/16% oil content
          Receiver Battery: 6V at least 1500mAh
          Air filter oil, glow starter, building and track equipment

SPECS:    Length: 17.4" (441.6mm)
          Width:  10.3" (262mm)
          Wheelbase: 8.5 / 7.95" (216 / 202mm) adjustable
          Tread: front, 8.5" (216mm)
                 rear, 7.9" (202mm) distance from outer edges of tires, side-
            to-side (adjustable front and rear)
          Front Caster Angle 8.5° - 15.5° adjustable
          Gear Ratio: 1st 7.35:1 / 2nd 5.52:1
          Weight: 5.51lbs (2500g)

COMMENTS: For replacement Ball Bearings use:
            Qty.  Size          Location          Qty.    Bearing Set
             2   12x18mm     Fr One Way            1        DTXC1597
             4   12x18mm     Fr Uprights           2        DTXC1597
             2   5x8mm       Servo Saver           1        DTXC1523
             2   10x15mm     Middle Shaft Bracket  1        DTXC1595
             2   12x18mm     Rear Bulkhead         1        DTXC1597
             4   12x18mm     Rear Uprights         2        DTXC1597
             2   size not given  Two Speed Unit        Mugen #H0608
             2   8x14mm      Two Speed Shaft       1        DTXC1583
             1   size not given  Belt Tensioner        Mugen #H0603
             2   5x10mm      Clutch                1        DTXC1535

                                                                   jxs 03/14/12
                                                                         ir/jxs