HPI Racing Nitro Star G3.0 Engine w/Pull Start

Tower Stock# HPIG1409  •  Manufacturer Stock# 15105
HPI Racing Nitro Star G3.0 Engine w/Pull Start (large view)
Notes from our tech department:
This is the HPI Nitro Star G3.0 Engine with Pull Starter
used in the HPI Fire Storm

FEATURES

Composite body rotary valve carburetor with 5.5mm bore
Silver colored cooling head
SG (pilot) type crankshaft
Two year limited warranty

INCLUDES

HPI Nitro Star G3.0 Engine with Pull Start, instruction manual,
R5 cold glow plug (HPIG1504), foam air cleaner assembly with four
zip ties, brass collet

REQUIREMENTS

Fuel: Car blend with 20-25% nitro content
Misc Items: Fuel tubing and track equipment

SPECIFICATIONS

Specs such as horsepower, bore, stroke and RPM were not provided-
contact HPI for further infomation
High Speed Needle Setting: Turn clockwise in 1/8 turn increments
to lean fuel mixture. Do not exceed 2-1/2 turns from flush
Idle Adjustment: Adjust for about 0.04" (1mm) gap between slide valve
and carb body at bore opening
Low Speed Needle: No adjustment recommended
Displacement: .18 cu in (3.0cc)

Distance Between Mounting Holes Same Side: 0.43" (11mm)
Distance Between Mounting Holes Opposite Side: 1.22" (31mm)
Height/Bottom Mounting Flanges to Top of Cylinder Head: 2.99" (76mm)
Height/Bottom of Crankcase to Top of Cylinder Head: 3.5" (89mm)
Length from Pull Starter to End of Crankshaft: 4.13" (105mm)
Length from Pull Starter to Front Bearing: 3.3" (75.3mm)
Length from Center of Crankcase to End of Crankshaft: 2.96" (75mm)
Diameter of Carburetor Bore: 0.21" (5.5mm)

kpm02/20/2007
ir/jxs

Resources
Parts Compatibility
Easy RC: Engines
‐ Manufacturer's Web Page ‐
‐ Mailing Address ‐
‐ Additional Contact Information ‐