This is the Opto-Isolated E-Switch with Hitec/JR/Z connector.|
This is a Solid-State Replacement for a Servo and Switch combined.
Adjustable ON point, reversing switch and LED indicator.
Optically isolated for no radio noise problems.
Use as "Old Timer" ignition cut-off, Glo driver switch,
Smoke pump control, or an On-Board Starter.
High Current Switching Capability
Selectable Stick Direction of ON/OFF
Positive Switching Point with Hysteresis for No Switch Center
Load Power Automatically Turns off when Receiver Power is Turned
Works with AM, FM, and PCM radios.
One Opto-Isolated E-Switch with Hitec/JR/Z connector.
One 6-1/2" piece of solder.
Soldering wires with included instructions.
Length: 1.47" (37.5mm)
Width: 1.56" (39.6mm)
Height: .75" (19.1mm)
Weight: .7 oz (20g)