This is an Electric Powered, Radio Controlled|
Dumas USS BLUEFISH (SS 222) Submarine Kit.
It is a dynamic diving submarine model.
Designed for advanced modelers.
Performed ABS plastic parts
Drive line hardware kit included
Step-by-step plans and instructions
Two 4.8V electric motors
One instruction manual
One set of plans (blueprints)
Vacuum formed hull, deck and motor mount
Vacuum formed sails (1/96-scale), and yes all submarines have sails.
One stiff paper pattern
One clear plastic (.020" for rudder, forward & rear dive planes)
One decal set
1- 3-channel radio (Minimum)
1- 7.2V battery
1- Battery charger for 7.2V battery
1- Electronic Speed Control
1- Hobby knife (No. 11 and No. 16 blades)
1- Duco cement (see COMMENTS)
1- Pro thin CA glue (GPMR6001)
1- Pro thick CA glue (GPMR6013)
1- Pro CA activator (GPMR6035)
1- 12" ruler (HCAR0460 is an 18" modeler ruler)
1- Silicone, non-corrosive Ultra-Gray RTV (see COMMENTS)
1- Polyester resin (purchase at automotive store)
1- Sandpaper (60-80 grit), Medium-(100-120 grit), Fine-(220-440 grit)
1- Paint brush (1/4", 1")
1- Acetone (purchase at hardware store)
1- Clamp set
1- File, 1/4" diameter
1- 24" long straight edge
1- Can polyester glazing putty (Bondo)(purchase at automotive store)
1- Soldering iron
1- Harris Stay Bright Solder
1- 3/4" wide masking tape
1- Drill bit set (1/32nd (No.67) through, 1/2" diameter)
1- White lithium grease
1- Buckshot (No.4, .240-Diameter)(no more than 5 lbs)
(purchase at gun supply store)
1- Petroleum jelly (tube, Not a jar)
Length: 33" (838mm)
Beam: 4" (102mm)
Height: 3-1/2" (89mm) (from top of deck to bottom of submarine)
Weight: 5 lbs (2268g) ready-to-run
Before you start any construction, Please Read The Entire Instruction
Manual To Acquaint Yourself With The Building Sequence Of This Kit.
Duco Cement: This is used to adhere plastic to stplasticyrene. It
sets up fast, but requires at least over night to cure thoroughly.
(purchase at a hardware store)
Silicone: This is used to seal all seams where there is the
possibility of water seeping in. It is also recommended to use
Non-Corrosive Ultra-Gray RTV Silicone by Permatex. Any gasket
style silicone will work, but make sure it is Non-Corrosive. A
large selection can be found at an automotive store.
Wood display stand shown with boat is not included.
updt jxs 12/12/03