Custom Works 1/10 Intimidator Gen 6 DD Pro-Comp EP Kit

Tower Stock# LW1823  •  Manufacturer Stock# 0916
Custom Works 1/10 Intimidator Gen 6 DD Pro-Comp EP Kit (large view)
Easy Pay
Request 3 Payments of $133.33 Details
Regularly Purchased Together
Although customers also purchased these, compatibility is not guaranteed. Click an item for product details.

Notes from our tech department:
This is the Electric Powered, Radio Controlled,
Pro-Comp Intimidator Gen 6 DD Dirt Oval Car from Custom Works R/C cars.
Includes all parts to build either a Dirt Modified (EDM) or a Latemodel.
Recommended for modelers 16 years of age and older.

FEATURES

Chassis: 0.12" (3mm) thick carbon fiber
Drive: DD (Direct Drive) rear wheel
Differential: Ball type with ceramic diff balls
Shocks: Four oil-filled, aluminum bodied with coil over spring,
updated design with screw-on seal caps and aluminum spring collar
with O-rings
Shock Towers: (3mm) thick carbon fiber, shock tabs move with chassis
location for greater simplicity
Differential: Ball type with ceramic diff balls
Suspension: Inclined spindles with adjustable control arms
Front Bumper: Foam
Spur Gear: Nylon construction 84 tooth 48 pitch
Caster: Adjustable front and rear, caster/toe-in refers to the angle
of the front suspension when viewed from the side of the car in
relation to the chassis
Camber: Adjustable, camber refers to the angle of the tops of the
tires from vertical when viewed from front or behind vehicle
Steering: Ball bearing equipped bell crank type, adjustable
Ackermann, Ackermann describes the effect of the inside front
wheel turning faster than the outer front wheel during turns

INCLUDES

Intimidator GEN 6 DD Pro Comp Chassis Kit with shocks, grease, spur
gear decal sheet, servo and battery mounts and instruction manual

REQUIREMENTS

Radio: 2-channel with one standard size servo
AA Batteries: 4 for transmitter
Motor: Brushless recommended, number of turn to be determined by
modeler
Pinion Gear: ASCC5258, 48 pitch to match spur gear, 21 tooth is
good starting point for the above motor
Electronic Speed Control: Compatible with number of turns of selected
motor
Battery: 2S LiPo recommended
Battery Charger: For selected battery
Body: 1/10 scale lightweight racing type
Building and track equipment

SPECIFICATIONS

Finished size such as length and width not provided by manufacturer

COMMENTS

For Replacement Ball Bearings use:
Qty. Size Location Qty. Bearing Set
4 3/16x3/8" Front Hubs 2 DTXC1423
4 3/16x3/8" Rear Hubs 2 DTXC1423
4 3/16x3/8" Transmission 2 DTXC1423
2 3/8x5/8" Transmission 1 DTXC1437
1 5/32x5/16" Diff Gear 1 DTXC1411

jxs 05/19/14
ir/jxs

Resources
Easy RC: Cars & Trucks
‐ Mailing Address ‐
‐ Additional Contact Information ‐