Novak M2 Dig 3S/Dual Terra Claw 55T Brushed Combo

Tower Stock# NOVC1848  •  Manufacturer Stock# 1848
Novak M2 Dig 3S/Dual Terra Claw 55T Brushed Combo (large view)
Notes from our tech department:
This is the Novak M2 Dig 3S/Dual Terra Claw 55T Motor/BEC Combo.

**This product is sold AS IS with no manufacturer warranty.**
**Return policy applies http://towerhobbies.com/policy-procedure.html.**

FEATURES

M2 Dig 3S ESC, NOVM1846
Independently powers the front or rear motors in a dual-motor
crawler, applicable for dual brushed motor or single brushed
motor applications
Compatible with any Super Crawler dual-system rig, such as Axial's
XR10, En-Route's Berg, Team Integy's Super and Unlimited class of
crawlers and Clod Buster based vehicles: also ideal for
applications that require two brushed motors such as robots, boats,
tanks and submarines
Four throttle profiles Dig, Proportional Dig, Single Output and Dual
Independent
Six adjustable parameters; Drag Brake, Dig Power, Dead Band,
Minimum Drive, Drive Frequency and Battery Selection
(LiPO, LiFe and NiMH)
Compatible with dual-brushed motor or single motor and accessory
item applications
Novak's Zero Reverse Delay provides immediate power delivery in both
forward and reverse
Universal JST Input Plug fits all popular brand receivers
Water-resistant case with gasket seal

55 Turn Terra Claw Brushed Rock Crawler Motor, NOVC3556
Lowest RPM and longest runtime of any brushed Novak motor
Very good low speed control and good amount of torque
Ideal for the budget minded crawling enthusiast, or the scale builder
needing a cost effective power plant
Equipped with brass bushings
Direct-Solder Wiring Tabs for flexible soldering options

INCLUDES

Novak M2 Dig 3S Electronic Speed Control with Receiver Plug, Power
Wires, two 55 Turn Terra Claw Motors, Cooling Fan, external BEC
Module, two external LED Harnesses, two 2-wire Input Harnesses,
to use with BEC, and Instruction Sheets

SPECIFICATIONS

M2 Dig 3S ESC;
Input Voltage: 2-3S LiPo/LiFe cells or 4-9 NiMH cells (1.2V/cell)
On-Resistance (dual motor): 0.0016 ohm at 25 C trans temp
On-Resistance (single motor): 0.0008 ohm at 25 C trans temp
Size: 1.16 x 1.47" (29.5 x 37.3mm)
Weight (w/o wires): 1.30oz (36.9g)
Motor Limit: 27-turn (2S), 33-turn (3S) 540-sized dual brushed motors
BEC: 6.0 volts DC/5.0 amps
Status LEDs: 4 on-board; 2 external
Voltage Cut-Off: 6.25V (2S LiPo), 4.75V (2S LiFe), 9.75V (3S LiPo)
7.125V (3S LiFe) (when LiPoly cut-off circuitry is enabled)
Power Wires: 14G super-flex copper-strand silicone wire
55 Turn Terra Claw Motor;
Input Voltage: 2S LiPo cells or 4-9 cells (1.2V/cell)
Motor Size: 1.96 x 1.40" (49.8 x 35.6mm)
Shaft Diameter: 0.125" (3.2mm) accepts all 1/8" pinion gears
Design: Stand-up brushed
Motor Weight: 5.8oz (164g)
Magnet: High-strength ferrite

jxs 04/28/15
ir/jxs

Resources
‐ Mailing Address ‐
‐ Additional Contact Information ‐