E-mail This Page To A Friend

                This is an Electric Powered, Radio Controlled
                  Dumas USS BLUEFISH (SS 222) Submarine Kit.
                   It is a dynamic diving submarine model.
                       Designed for advanced modelers.

FEATURES: Performed ABS plastic parts
          Drive line hardware kit included
          Step-by-step plans and instructions
          Decals

INCLUDES: Two 4.8V electric motors
          One instruction manual
          One set of plans (blueprints)
          Vacuum formed hull, deck and motor mount
          Vacuum formed sails (1/96-scale), and yes all submarines have sails.
          One stiff paper pattern
          One clear plastic (.020" for rudder, forward & rear dive planes)
          One decal set

REQUIRES: 1- 3-channel radio (Minimum)
          1- 7.2V battery
          1- Battery charger for 7.2V battery
          1- Electronic Speed Control
          1- Hobby knife (No. 11 and No. 16 blades)
          1- Duco cement (see COMMENTS)
          1- Pro thin CA glue  (GPMR6001)
          1- Pro thick CA glue (GPMR6013)
          1- Pro CA activator  (GPMR6035)
          1- 12" ruler (HCAR0460 is an 18" modeler ruler)
          1- Silicone, non-corrosive Ultra-Gray RTV (see COMMENTS)
          1- Polyester resin (purchase at automotive store)
          1- Sandpaper (60-80 grit), Medium-(100-120 grit), Fine-(220-440 grit)
          1- Paint brush (1/4", 1")
          1- Acetone (purchase at hardware store)
          1- Clamp set
          1- File, 1/4" diameter
          1- 24" long straight edge
          1- Can polyester glazing putty (Bondo)(purchase at automotive store)
          1- Soldering iron
          1- Harris Stay Bright Solder
          1- 3/4" wide masking tape
          1- Drill bit set (1/32nd (No.67) through, 1/2" diameter)
          1- White lithium grease
          1- Buckshot (No.4, .240-Diameter)(no more than 5 lbs)
             (purchase at gun supply store)
          1- Petroleum jelly (tube, Not a jar)
             Clothes Pins

SPECS:    Length: 33"     (838mm)
          Beam:    4"     (102mm)
          Height:  3-1/2"  (89mm) (from top of deck to bottom of submarine)
          Weight:  5 lbs (2268g) ready-to-run

COMMENTS: Before you start any construction, Please Read The Entire Instruction
            Manual To Acquaint Yourself With The Building Sequence Of This Kit.
          Duco Cement: This is used to adhere plastic to stplasticyrene. It
            sets up fast, but requires at least over night to cure thoroughly.
            (purchase at a hardware store)
          Silicone: This is used to seal all seams where there is the
            possibility of water seeping in. It is also recommended to use
            Non-Corrosive Ultra-Gray RTV Silicone by Permatex. Any gasket
            style silicone will work, but make sure it is Non-Corrosive. A
            large selection can be found at an automotive store.
          Wood display stand shown with boat is not included.

                                                                    jct 5/13/01
                                                              updt jxs 12/12/03



– If you need more information, use these Dumas resources –

Web Site: http://www.dumasproducts.com/
Phone: 800-458-2828


 
Postal Address:
Dumas
909 EAST 17TH STREET
TUCSON, AZ 85719  








Click here for Units of Measure Conversion Calculators