This is the PHOTON SPEED MOTOR (20 turn, single wind) from Duratrax.
This is the stock motor found on the Duratrax Evader.
FEATURES: Great for monster trucks
20 Turn
Open endbell, brushes and springs are replaceable
Bushing motor
Standard (not laydown) brushes
Non-adjustable timing
INCLUDES: One motor
Two pre-installed capacitors
Pre installed bullet-type motor leads
REQUIRES: Two 3mm mounting screws
Bullet-type leads for speed control, if needed (TRIC5500)
SPECS: Turns: 20
Winds: 1 (single_wire)
Stock for 7.2-8.4 volt battery
Uses oilless type brushes
Shaft Diameter: 3mm
Shaft Length: 12mm
Overall Length: 68mm
Outside Diameter: 36mm
COMMENTS: BREAK-IN
For proper break-in, use a 3-5volt power source, run the motor with
no load. The contact patch should take up at least half of each
brush's surface. Do NOT use more than 5volt power, as the
commutator may be damaged.
MAINTENANCE:
Brushes wear out! Continuing to use worn brushes will ruin the
commutator and interfere with its ability to conduct electricity
(the worn part of the commutator will appear dark). Overhaul your
electric motor often. Inspect the brushes at the first sign of
wear usually after 5 to 10 packs are run). Inspect and
clean the Brush Holder frequently. The contact between the brush
and the commutator becomes bad if the brush holder is filled
with dust or dirt. If brushes show sign wear, replace the pair.
NNA 10/27/01
ir/kh
updt jxs 4/21/09
Click here for Units of Measure Conversion Calculators