O.S. Speed B2102 Competition Engine

Tower Stock# LXGJVT  •  Manufacturer Stock# 1A300
  • front/side (see larger view)
  • rear/side (see larger view)
  • top (see larger view)
  • bottom (see larger view)
  • out of package (see larger view)
  • packaging (see larger view)
Quantity Discounts Available
L5GJVT02
Save $45.00
2 for $954.98
Regularly Purchased Together
Although customers also purchased these, compatibility is not guaranteed. Click an item for product details.

Notes from our tech department:
This is the O.S. Engines Speed B2102 1/8 scale Competition Buggy Engine.

****** Because of the expressed racing nature of this engine, ******
****** it is NOT covered by the O.S. 2 Year Warranty ******

FEATURES

Low cylinder head reduces the buggy's center of gravity by 0.67"
(17mm) for better stability during aggressive driving
Newly designed 22C slide valve carburetor for better fuel economy
Tungsten weighted crankshaft with diamond-like coating and silicon
potting
Bypass of crankcase is modified for better performance

INCLUDES

O.S. Engines Speed B2102 Engine with P3 Turbo Glow Plug
6.5mm Carburetor Reducer in Red
Exhaust Seal Ring
One each 3mm, 16mm and 18mm Dust Caps
Instruction Manual

REQUIREMENTS

Exhaust System such as the O.S. Engines T2090SC Tuned Pipe
Fuel: 10-30% nitro content, 20% recommended for break-in
Air filter, glow starter and track equipment

SPECIFICATIONS

Engine;
Displacement: 0.211 cu (3.46 cc)
Bore: 0.646 in (16.40 mm)
Stroke: 0.646 in (16.40 mm)
Practical RPM: 4,000-42,000
Power Output: 2.65 PS/2.61 hp @ 34,000 rpm
Crankshaft Size: UNF1/4-28
Distance/Mounting Hole Centers Same Side: 0.83" (21mm)
Distance/Mounting Hole Centers Opposite Side: 1.45" (37mm)
Width of Crankcase below Mounting Tabs: 1.2" (31.6mm)
Width of Mounting Tabs: 1.8" (45mm)
Height/Mounting Tab to top of Cylinder Head: 2.6" (65.9mm)
Height/Mounting Tab to center of Exhaust Outlet: 1.1" (28mm)
Height Crankcase Bottom to top of Cylinder Head: 3.2" (81.5mm)
Length of Crankshaft end to Front Bearing: 1.2" (29.5mm)
Length of Crankshaft end to Backplate: 3.7" (94mm)
Length of Crankshaft end to Center of Crankcase: 2.9" (73.5mm)

Carburetor Settings;
(Carburetor is preset from factory and should only require very
small adjustments)
Needle Valve: 3 turns open from fully closed
Mixture Control Valve: One turn screwed in from flush position with
carb body
Metering Needle: 0.3-0.4mm protruding from flush position with carb
body
Throttle Stop Screw: Approximately 0.5mm from carb body when viewed
from above

jxs 12/03/17
ir/jxs

Resources
Easy RC: Engines
‐ Manufacturer's Web Page ‐
‐ Mailing Address ‐
‐ Additional Contact Information ‐