E-mail This Page To A Friend

    This is a 1/48 Plastic F-111E Aardvark Strategic Bomber Model Kit from
                 Academy Plastics.  It's for ages 10 and up.

     The General Dynamics F-111E is a versatile multi-purpose fighter-bomber
in the service of the USAF. Based on the original F-111A, the -E version
differs primarily in the use of the revised "Triple-Plow II" engine inlet.
Like the preceding -A model, the -E was designed with the Radar Homing and
Warning gear (RHAW) installed. Hardpoints for additional electronics are
located under the wings and fuselage. The total production run for the F-111E
amounted to 94 units.

FEATURES: Plastic pieces attached to sprues and molded in grey.
          The surface of the plane is decorated with fully engraved panel
            lines and rivet detail.
          Highly detailed cockpit interior is filled with an accurately
            modeled seat and controls.
          Wings may be assembled in an extended or swept back position.
          Detailed exhaust cones add to the realism of the model.
          Arresting hook assembly is included.
          The hard-point loadouts include an ECM, a bomb dispenser, AIM-9
            sidewinder missles, and extra fuel cells.
          Clear plastic canopy allows close inspection of cockpit.
          Detailed pictorial instructions guide you through assembly.

MARKING
OPTIONS:  One Decal Sheet with Markings for One Aircraft:
            1: USAF General Dynamics F-11E Aardvark Strategic Bomber
          Airframe Colors:
            1: Glossy Black, Tan FS, Dark Green FS, Medium Green FS
          Detail Colors:
            Gloss White, Light Gray, Flat Black, Black, Gray, Steel, White
            Red

INCLUDES: One 1/48 Plastic F-111E Aardvark Strategic Bomber Model Kit

REQUIRES: Assembly
          Cement
          Paint (see MARKING OPTIONS)
          Brushes
          Sprue Cutter
          Modeling Knife
          File or Emery Board
          Scissors
          Tweezers
          Water for Decals
          Glue Tips or Toothpicks
          Cloth
          Adult Supervision

SPECS:    Scale:    1/48
          Length: 10-1/4"  (259mm) (approximately)
          Width:      16"  (406mm) (approximately)
          Height:      3"  (75mm)  (approximately)

COMMENTS: Keep small parts and sharp edges away from children.
          Care should be taken when using tools and modeling knives.
          Modeling paint should only be used by an adult in a well-ventilated
            area.
                                                                     jtt 8/9/00
                                                                          ir/jl



– If you need more information, use these Academy resources –

E-mail: mrcsupport@modelrectifier.com
Web Site: http://www.academy.co.kr/
Phone: 732-225-2100


 
Postal Address:
Academy
C/O MODEL RECTIFIER CORPORATION
80 NEWFIELD AVENUE
EDISON, NJ 08837  








Click here for Units of Measure Conversion Calculators