E-mail This Page To A Friend

      This is the LRP Quantum Pro Sport Digital Electronic Speed Control
              that is distributed in the USA by Team Associated.

FEATURES: Ultra High Performance using latest SMD-MOSFETs(Transistors)
          Super-light for improved chassis handling
          Small in size
          Battery recharge during braking
          FET Servo Lead, for powering an FET Servo
          Extra strong Brake-Power
          Real-time braking
          Standard Battery Connector(Tamiya-style)
          Bullet-style Motor Connectors
          Motor & Battery wires pre-soldered

INCLUDES: One Quantum Pro Electronic Speed Control w/S-style radio connector
           (for Hitec, JR, and Airtronics "Z" radio systems).
          One Futaba J style connector
          One Airtronics style connector(Old, pre-"Z" style)
          One Adjusting stylus, used for high-speed and set-up adjustments
          One Blue-anodized Heat Sink
          Three .1uf capacitors
          One polarized Schottky diode
          Three small 4" zip-ties
          One 1.5"x 1.5" double-sided tape, for mounting ESC to chassis
          Three 1/2"x7/8" double-sided tape, for mounting heat-sink
          Two 3.5"x5" LRP decal sheets

REQUIRES: TRIC5500(no-solder connectors) if needed, to attach motor wires
           from speed control.

SPECS:    Length of case: 25.4mm   (1")
          Width of case:    23mm  (.9")
          Height of case:   16mm (.63")
          Length of motor wires: 127mm (5")
          Length of battery wires, including connector: 102mm (4")
          Length of receiver lead-wire: 191mm (7.5")
          Length of ON/OFF switch wire: 102mm (4")
          Voltage range: 4-8 cells (4.8V-9.6V)
          Internal resistance: .00073 ohms
          Momentary load: 155A
          Pulse frequency: 2500Hz
          Brief load:      80A
          Continuous load: 55A
          Recommended motor limit: 7+ turns
          Receiver voltage: 5V
          Max. receiver current(30 sec): 2A
          Continuious receiver current(5 min): 1.2A
          Weight: 15g (.53 oz)

COMMENTS: Schottky diode and capacitors will need to be soldered to motor

                                                                   NNA 11/21/01
                                                                          ir/kh




– If you need more information, use these Associated resources –

Web Site: http://www.rc10.com/
Phone: 949-544-7500


 
Postal Address:
Associated
26021 COMMERCENTRE DR
LAKE FOREST, CA 92630  








Click here for Units of Measure Conversion Calculators