View Larger Picture

Parts Express Eligible:	Yes
E-mail This Page To A Friend

           This is a motor mount drilled and tapped to fit O.S.
             61SF, 61SF-P, 61RF, 61RF-P, 60FP, 61FX (2-stroke)
  Includes all hardware necessary for mounting the engine to a firewall and to
mount an engine to the engine mount. The nose gear hole is not pre-drilled.

INCLUDES: Four engine mounting screws (to secure the engine to the mount)-
            M3.5x16
          Four lock washers (for the engine mounting screws)
          Four blind nuts (they fit into the firewall)
          Four motor mount screws (to secure the mount to the firewall)-
            M4x20
          One L-wrench for the screws

SPECS:     Type of Material: All Aluminum mount with Steel screws and washers
           Type of Mount: Beam Style, Square Shaped Back
           Length: 78mm (3")
           Width: 45mm (1.77")
           Height: 45mm (1.77")
           Center Distance Between Firewall Mounting Holes: 46.6mm
      **   Distance from firewall to first engine mounting hole: 37mm

COMMENTS:  The firewall mounting holes are in a square configuration, so C.D.
             dimension would apply to top and bottom and side to side. cmc 9/01

                                                                     JBN 7.6.93
                                                                          ir/jl
                                                     ** updated ** cmc 05/12/05



– If you need more information, use these O.S. resources –

E-mail: enginesupport@hobbico.com
Web Site: http://www.osengines.com/
Phone: 217-398-8970


 
Postal Address:
O.S.
3002 N. APOLLO DRIVE, SUITE #1
CHAMPAIGN, IL 61822  








Click here for Units of Measure Conversion Calculators