Parts Express Eligible:	Yes
E-mail This Page To A Friend

            This is a Dual E-Switch for Futaba Radios by EMS

FEATURES: Lightweight Design
          Control Two Functions with one Radio Channel
          Each Output is rated for 5 continuous amps and up to 30 volts
          Each Output can be configured for Momentary of Latching Mode

INCLUDES: One E-Switch Unit
          One Length of Solder
          One Instruction Sheet

REQUIRES: Soldering of Wires to Unit

SPECS:    Length: 1.5"
          Width:  1.5"
          Height: 0.75"
          Wire Length: 11"

COMMENTS: Negative of battery gets soldered to two center hole on the board.
            Positive wires from function (Motor, etc.) get soldered to the
            holes closest to the MOSFETs.
          Momentary mode means function will be ON while the radio stick is
            away from center. When stick returns to center function will turn
            OFF.
          Latching means function will turn ON and remain so when stick is
            moved from center. Function will turn OFF when stick is
            moved again in the same direction.
          Unit is basically an ON/OFF switch that is controlled by the radio
            stick. It would be similar to having extra switches on the
            radio itself.
          Unit is NOT proportional.
          If either output of the Dual E-Switch is used to control a motor,
            install a diode (1N4001) between the motor and the terminals.
                                                                     jmm 6/1/02
                                                                          ir/kh



– If you need more information, use these EMS resources –

E-mail: mark@emsjomar.com
Phone: 800-845-8978


 
Postal Address:
EMS
22605E LA PALMA AVE. STE 516
YORBA LINDA, CA 92887  








Click here for Units of Measure Conversion Calculators