Click for parts for this item

 Eligible: Yours for 3 Easy Pay payments of $99.99
Select Easy Pay Plan during checkout.

View Larger Picture

Instruction Manuals:	Manual 1 (643 KB)
Tower Catalog Page:	200
E-mail This Page To A Friend

        This is the .70 SZ-H Ring Engine from O.S. designed with the
                           FAI F3C Pilot in mind.

FEATURES: Ringed for long life.
          3-needle carb for ultimate tuning precision. (Settings are covered on
            pages 14 & 15 of the manual)

                          High Speed:   2 turns OUT
                          Medium Speed: 1 tunn OUT
                          Idle Mixture: Refer to picture on page 14

          Two extra mounting lugs on front allow modelers to mount engine
            securely in helis.
          Designed with the FAI F3C competitor in mind, allowing 3D pilots an
            edge over the standard .60 size engine.
          Throttle assembly reference marks make it easy to note and restore
            finely tuned settings after maintenance.
          Front and rear ball bearing-supported crankshaft reduces friction
            and wear.
          Large heli cylinder head offers generous cooling fin area, with
            increased webbing on crankcase front for heat dissipation.
          Installs in the same space as a .61 engine.

INCLUDES: One .70SZ-H Ringed Helicopter engine
          #8 OS Glow Plug  and Decals

REQUIRES: Muffler & Fuel

SPECS:   Displacement: 11.50cc (.702cu in)
         Bore: 25.8mm (1.016in)                Stroke: 22.0mm (.866")
         Power Output: 2.5HP at 16,000 RPM     Weight: 553.5g (19.5oz)
         Practical RPM Range: 2,000 - 18,000 RPM
         Crankshaft Thread Size: 5/16-24
         Length: 81.3mm  Backplate to the front of the crankcase
         Width:  42.6mm  width of engine neglecting the mounting flanges
                 25mm    distance between mounting hole centers
                 60mm    Distance from rear mount to front mount centers
                 52mm    Side to side centers of rear mounting holes
                 42mm    Side to side centers of foremost mounting holes
                 42mm    distance between mounting holes for exhaust

         Needle Settings: High Speed: 2 turns out from fully closed
                          Mixture Control (low speed) indentation on screw head
                                      straight vertical (up and down)
                          Medium Range: 1 turn open

COMMENTS: Engine is shipped with the carb lightly fitted. Be sure to tighten
          prior to use.

COMMENTS: This engine will fit in most .60 size helicopters, and should work
           well without the need for gear changes.

                                                                     kh06-27-02
                                                            updated rjm 8-19-02
                                                                          ir/kh
                                                               updt lmm 4/14/09



– If you need more information, use these O.S. resources –

Click Here: Manufacturer's Product Web Page
E-mail: enginesupport@hobbico.com
Web Site: http://www.osengines.com/
Phone: 217-398-8970


 
Postal Address:
O.S.
3002 N. APOLLO DRIVE, SUITE #1
CHAMPAIGN, IL 61822  








Click here for Units of Measure Conversion Calculators