Parts Express Eligible:	Yes
E-mail This Page To A Friend

 This Clutch Shoe Kit for .21 OS Max Engines gives More Surface Area Than a Two
Shoe Design, Which Gives You Better Clutch Bell Grip and Improved Acceleration.

INCLUDES: One Aluminum 4-Pin Flywheel (solid, not drilled out for lightness)
          One Clutch Nut (holds flywheel onto crankshaft)
          One Washer with Holes for Flywheel Pins (10x24mm)
          Four Black Clutch Shoes
          Fout Clutch Springs
          One Wide Aluminum Spacer (6.5mm thick)
          One Narrow Aluminum Spacer (4.5mm thick)
          One 5.5x9.5mm thick Shim/Washer
          Three 5x8mm thin Shim/Washer
          One 3x5mm Cap Screw
          One 3.5x8mm Washer
          One Instructions

REQUIRES: Bearings for the Clutch Bell are DTXC1535.
          Clutch Bells DTXC2521 DTXC2526.

COMMENTS: The replacement shoes for this kit are DTXC2545.
          Will NOT work on the Inferno MP-5.
          WILL NOT WORK ON ENGINES WITH A PILOT SHAFT
          This kit may be used on the TORQ 21. You need to use the Drive
            washer for the TORQ 21 DTXG0565 instead of the spacer.
          The current clutch kit has a revised clutch nut that eliminates the
            large e-clip.  The e-clip is no longer included in the package, and
            this change has no effect on the attachment or operation of the
            clutch kit.
                                                                    KLH 9/03/00
                                                                          ir/jl



– If you need more information, use these DuraTrax resources –

Click Here: Manufacturer's Product Web Page
E-mail: carsupport@duratrax.com
Web Site: http://www.duratrax.com/
Phone: 217-398-8970


 
Postal Address:
DuraTrax
3002 N. APOLLO DRIVE, SUITE #1
CHAMPAIGN, IL 61822  








Click here for Units of Measure Conversion Calculators