E-mail This Page To A Friend

      This is the Pro .15 to TRX 2.5 engine conversion set from Traxxas.
            It allows you mount the newer 2.5 engine to an older
               Nitro Rustler, Nitro Sport and Nitro Stampede.

FEATURES: Tuned pipe & throttle servo horn made of plastic
          Linkage wire made of steel
          Engine mount made of aluminum

INCLUDES: One Plastic Tune Pipe (TRAG4452)
          One Exhaust Header w/Screws & O-ring (TRAC5287)
          One Exhaust Coupler (TRAG5246)
          One Slide Carb Linkage Set
          Two Tie-Straps for mounting Exhaust Coupler
          One 3x10mm machine cap screw w/washer
          One Transmission Brace (TRAC4434)
          Three Tune Pipe Hanger Wires, one for each: Nitro Rustler,
            Nitro Sport, and Nitro Stampede
          One Engine Mount set (TRAC4460)
          One instruction sheet

REQUIRES: 2.5 engine and stock clutch system

SPECS:    Tuned Pipe Length:             114mm  (4.5")
          Header Pipe Outer Diameter:    13mm    (.51")

COMMENTS: If EZ-Start system is needed, use TRAP5271

                                                                    NNA 5/18/03
                                                                         ir/jxs



– If you need more information, use these Traxxas resources –

E-mail: support@traxxas.com
Web Site: http://www.traxxas.com/
Phone: 888-872-9927


 
Postal Address:
Traxxas
1100 KLEIN RD
PLANO, TX 75074  








Click here for Units of Measure Conversion Calculators