E-mail This Page To A Friend

              This is Traxxas's TRX 2.5cc Engine with Pull-Start.
 This version of the engine is equipped with two different length crankshafts.
                 60% More Power that the TRX Pro .15 engine!
  ** This engine is a .15 engine. The 2.5 refers to a measurement of Cubic **
      Centimeter displacement compared to Cubic Inch displacement (.15).
  Loaded with advanced features such and the free flowing rear exhaust, the
  unique composite slide carb, and innovative porting only found on the most
                          exotic racing engines.

FEATURES: Slide carburetor provides less restrictive, straight through airflow
            for more power and better throttle response.
          Exhaust Header features an extra-tough, finned mounting base that
            dissipates heat and is sealed with a reliable O-ring gasket.
          Molded head protector prevents damage to the head and secures the
            glow plug wire.
          Innovative cast cylinder head is engineered for the most heat
            reduction possible.
          Tubular header features smooth, rounded bends to eliminate exhaust
            flow restriction and turbulence.
          Ultra-low restriction air filter provides superior air flow and
            filtration for more power and a long engine life.
          Offset wrist pin further reduces piston slide loading for more
            even cylinder wear, and longer engine life.

INCLUDES: One 2.5 (0.15cu in) Engine with pull starter w/flywheel nut
          One 25mm crankshaft end
          One 15mm crankshaft end
          One 90 degree air filter (includes base for upright mounting)
          One 22 chapter Engine Set-up DVD
          One owner's manual/instruction booklet
          One bottle of air filter oil
          One decal sheet

REQUIRES: Muffler (exhaust system) depending on vehicle
          Starting equipment
          Traxxas 10-20% "Top Fuel" nitro fuel. TRAP5010 or TRAP5020

SPECS:    Displacement:                                   0.15 cu in (2.49cc)
          Crankshaft Thread:                                 5mm
          On-Center Mounting Holes, Front to Rear:          11mm (.433")
          On-Center Mounting Holes, Side to Side:         31.4mm (1.24")
          Back of engine(recoil)to front of drive washer: 73.2mm (2.88")
          Height:                                         97.3mm (3.83")
          Exhaust Port Diameter:                  inner -  9.9mm (.392")
                                                  outer - 13.0mm (.512")

COMMENTS: This engine shares the same mounting dimension as the O.S. .12-.15 CV
            Series recoil engines.
                                                                   cmc 08/01/03
                                                                         ir/jxs



– If you need more information, use these Traxxas resources –

E-mail: support@traxxas.com
Web Site: http://www.traxxas.com/
Phone: 888-872-9927


 
Postal Address:
Traxxas
1100 KLEIN RD
PLANO, TX 75074  








Click here for Units of Measure Conversion Calculators