This is the Ram On-Board Glow Driver and Glow Starter
for use with all radio systems.
**Requires an amplifier to work with the Futaba 2.4GHz receivers**
**and some Spectrum receivers. Contact Ram directly for the amplifier.**
**Does NOT require an amplifier to work with Futaba PCM**
**and Hitec RCD receivers.**
FEATURES: Sub-C cell can be recharged
LED monitor indicates unit is engaged
Optically coupled
Reversible
Automatic shut-off
INCLUDES: 1800mAh Sub-C cell
LED indicator/monitor
Charge lead with NO CONNECTOR
One shrink-wrapped battery holder which also houses circuit board
SPECS: Main unit:
Height: 1-1/2"
Width: 1-1/4"
Length: 2-1/4"
REQUIRES: Charger recommended to charge battery is (HCAP0100).
'Y' harness from receiver to servo and igniter (HCAM2500).
Female universal connector for charge jack. (HCAM2030).
Amplifier, if using with Futaba 2.4GHz and some Spectrum receivers
COMMENTS: There are five series of wires coming off the main unit:
Ground lug-12" of wire
wire-12" of wire
LED monitor-12" of wire
Rx wire-7" of wire
Charge lead-10" of wire with NO CONNECTOR
HCAM2030 will require removal of the male end. MAF10/20/98
ir/jl
updt cdh8/11/03
updt jxs 11/08/04
updt jxs 3/31/09
– If you need more information, use these Ram resources – |
Web Site: http://www.ramrcandramtrack.com/
Phone: 847-740-8726
|
|
Postal Address:
Ram
229 EAST ROLLINS ROAD
ROUND LAKE BEACH, IL 60073
|
Click here for Units of Measure Conversion Calculators
Yes
E-mail This Page To A Friend
