Parts Express Eligible:	Yes
E-mail This Page To A Friend

  This is the GMS Carb Assembly for their .47 ABC Front Needle engine.

FEATURES: Aluminum body construction
          Rotary type throttle
          Steel throttle arm
          Set screw at the end of needle valve to mount a scratch-built
            needle valve adjusting rod
          Throttle stop screw with lock nut for easy idle adjustments
          Low speed adjustment via mixture control centered in throttle arm

INCLUDES: One assembled carb for the GMS .47 front needled engine

REQUIRES: Assembly to engine

SPECS:    Height:                        34.1mm (1.34")
          Bottom Throat inner diameter:   9.9mm (.390")
          Bottom Throat outter diameter:   13mm (.512")
          Intake Port inner diameter:       8mm (.315")
          Intake Port outer diameter:    13.3mm (.524")

COMMENTS: If Carb Retainer Nut is needed, use GMEG2665
          A .062" wire (not included) can be used to extend the needle valve by
            inserting the wire into the pre-drilled hole on the end of needle
            valve and tightening it in place with the supplied set screw.

                                                                     tjt 080803
                                                                         ir/jxs



– If you need more information, use these GMS Engines resources –

Phone: 217-398-8970


 
Postal Address:
GMS Engines
1610 INTERSTATE DRIVE
CHAMPAIGN, IL 61822  








Click here for Units of Measure Conversion Calculators