Parts Express Eligible:	Yes
E-mail This Page To A Friend

  This is the GMS Carburetor Assembly/Remote Needle set for the 1.20 Engine.

FEATURES: Set screw at the end of needle valve to mount a scratch-built
            needle valve adjusting rod.
          Low Speed adjustment via mixture control centered in throttle arm
          Steel throttle arm and needle valve mount
          Aluminum construction.

INCLUDES: One remote needle valve with mounting bracket.
          One small section of clear fuel tubing.
          One assembled carb.

SPECS:    Length:                        21mm (0.83")
          Width:                         51mm (2.02")
          Height:                        38mm (1.49")
          Diameter of carburetor base:   15mm (.59")
          Diameter of carburetor intake: 15mm (.59")
COMMENTS: If Carb Retainer Nut is needed, use GMEG2680
          A .062" wire (not included) can be used to extend the needle valve by
            inserting the wire into the pre-drilled hole on the end of needle
            valve and tightening it in place with the supplied set screw.

                                                                    ajw 08/8/03
                                                                         ir/jxs



– If you need more information, use these GMS Engines resources –

Phone: 217-398-8970


 
Postal Address:
GMS Engines
1610 INTERSTATE DRIVE
CHAMPAIGN, IL 61822  








Click here for Units of Measure Conversion Calculators