E-mail This Page To A Friend

           This is the Fuselage for the Hobbico HobbiStar 60 MKIII.

FEATURES: Construction: All balsa and plywood
          Covering: Factory applied adhesive backed (not carried separately)
             Colors are Blue and White with Red and Orange stripes.
          Cast aluminum engine mount.

INCLUDES: One pre-built and pre-covered fuselage with pre-installed pushrod
          tubes and cast aluminum engine mount.
          One plywood servo tray
          Two 1/4x1/2x10"(6x12x255mm)balsa sticks for fuel tank, receiver and
          battery mounting.
          Two plastic antenna tubes.

REQUIRES: Rest of airplane,radio and engine.

SPECS:    Length: 55" (1400mm)

COMMENTS: If purchasing this as a replacement for the RTF fuselage set, there
          will be more assembly required than with the original RTF fuselage.
          See http://www.hobbico.com/manuals/hcaa2125-manual-v1_1.pdf
          for instructions on how to assembly this fuselage.
                                                                     wm 5/23/03
                                                                         ir/jxs




– If you need more information, use these Hobbico resources –

E-mail: airsupport@hobbico.com
Web Site: http://www.hobbico.com/
Phone: 217-398-8970


 
Postal Address:
Hobbico
3002 N. APOLLO DRIVE, SUITE #1
CHAMPAIGN, IL 61822  








Click here for Units of Measure Conversion Calculators