Tower Catalog Page:	77
E-mail This Page To A Friend

This is a large scale retractable tailwheel with forked axle for the tailwheel
and air cylinder. For use with planes upto 40 lbs.

FEATURES: This Unit Comes Pre-Assembled with an Air Cylinder and Tailwheel
            Axle Attached.
          Steerable with a Pull-Pull System Attached to the Rudder Servo.

INCLUDES: One Retractable Tailwheel w/Air Cylinder and Tailwheel Fork Axle
          One Instruction/Parts List Sheet

REQUIRES: Pressure Tubing to Reach from the Main Control Unit to the Air Ram
          One 2" Tailwheel
          Plastic Sleeved Pull-Pull Steel Steering Cables(Goes to Rudder Servo)
          Four #6-32 Mounting Screws
          Four #6-32 Blind Nuts
          Four 3/8" x 1/2" Maple Mounting Blocks
          Four Dowel Pins (Used to Mount Maple Mounting Blocks to Bulkhead)
          Epoxy
SPECS:    Retract Mounting Brace Height: 2-11/16" (68.5mm)
          Retract Mounting Brace Width:  2"
          Height from Axle Center to Bottom Retract Brace: 2-1/8" approx.
          Extended Length from Axle Center to Retract Brace Mount: 3-11/16"
          Retracted Length from Axle Center to Retract Brace Mount: 4-1/8"

COMMENTS: On the Air Cylinder: Extend Fitting is Located Forward and the
                               Retract Fitting is Located Aft.
          For the Offset Axle Version, use ROBQ2225.
                                                                     JAL 2/2/99
                                                                          ir/jl



– If you need more information, use these Robart resources –

E-mail: robart@robart.com
Web Site: http://www.robart.com/
Phone: 630-584-7616


 
Postal Address:
Robart
625 N. 12TH STREET
ST. CHARLES, IL 60174  








Click here for Units of Measure Conversion Calculators