This is a Variable Rate Air Control Kit from Robart for Any Pnuematic Retract
System. This Allows the modeler to Control the rate at which the Retracts go
Up and Down. This can be used with either a 3 gear or a 2 gear setup. This
Air Control Kit comes with Everything Needed to Complete Any of the Robart
Pneumatic Retract Setups.
INCLUDES: One Instruction Sheet
One Variable Control Valve
Five Tee Fittings-Nylon
One Air Fill Valve
One 5ft of Purple Tubing
One 5ft of Red Tubing
Six Retaining Nuts
One Small Air Vessel (Tank)
SPECS: Air Control Valve Length: 2"
Width: 1/2"
Air Vessel Length: 6 1/2"
Diameter: 1-3/4"
REQUIRES: Pressure gauge, ROBQ0173
COMMENTS: Again this kit will work with any manufacturer's pneumatic retract
set.
6-16-97 djg
ir/jl
– If you need more information, use these Robart resources – |
E-mail: robart@robart.com
Web Site: http://www.robart.com/
Phone: 630-584-7616
|
|
Postal Address:
Robart
625 N. 12TH STREET
ST. CHARLES, IL 60174
|
Click here for Units of Measure Conversion Calculators
| 
Yes
E-mail This Page To A Friend
