E-mail This Page To A Friend

              This is the Midwest Stand-In Portable Workstation.

FEATURES: For R/C planes, boats, and vehicles
          Three ways to support different models, fits virtually any design
          Sliding uprights adjust to width of model (maximum distance between
            uprights is 16" (406mm)
          Cradles constructed of steel covered in protective rubber padding
          Plastic parts tray features three compartments with slide-up ramps
            allows easy pick-up of parts
          Easy no tools required assembly

INCLUDES: One Midwest Stand-In Portable Workstation with plastic parts tray

REQUIRES: Assembly

SPECS:    General Dimensions:                   Parts Tray Dimensions:
          Width:  17½" (445mm)               Width:   8"     (203mm)
          Depth:   12" (305mm)               Length: 12"     (305mm)
          Height: 13¾" (349mm)_              Depth:     ¾" (19mm)

COMMENTS: Do not start any type of electric motor or nitro engine while model
            is in stand.  Starting motor or engine may cause the stand to tip
            or fall over resulting in personal injury.

                                                                    jxs 3/05/04
                                                                         ir/jxs




– If you need more information, use these Midwest resources –

E-mail: customerservice@midwestproducts.com
Web Site: http://www.midwestproducts.com/
Phone: 800-348-3497


 
Postal Address:
Midwest
PO BOX 564
HOBART, IN 46342  








Click here for Units of Measure Conversion Calculators