Parts Express Eligible:	Yes
E-mail This Page To A Friend

               This is a Slimline Pitts Style Muffler for the
              SuperTigre S .61K (tapped holes in engine) Engine.

FEATURES: Compact side mount for wide, but vertically compact cowls.
          Directs exhaust gasses out bottom of cowl at slight back-facing
            angle for clean routing.
          4-baffles
          Pressed and brazed fittings using high-quality aluminum bar and
            tubing.
          Exhaust tubes are 2 1/2"long, but may be cut to fit any dimension.

INCLUDES: One Muffler
          One Pressure Fitting
          Two Mounting Bolts

SPECS:    Length: 2-1/5"    Width: 3 1/5"    Height: 3"

REQUIRES: Muffler Gasket Material.
COMMENTS: The bolts slip through the exhaust into a threaded engine.
          If the motor is not threaded,(Example: SUPG0161 or SUPG0181,
            SuperTigre G61) they will require SUPG4785.
            These are a 3.5 x 35mm screws that run through engine and muffler
            and tighten with nuts.
                                                                   krm 10/23/98
                                                                          ir/jl



– If you need more information, use these Slimline resources –

E-mail: support@slimlineproducts.com
Web Site: http://www.slimlineproducts.com/
Phone: 480-967-5053


 
Postal Address:
Slimline
PO BOX 3295
SCOTTSDALE, AZ 85257  








Click here for Units of Measure Conversion Calculators