Parts Express Eligible:	Yes
E-mail This Page To A Friend

    This is a Manifold That Adapts a Tuned Pipe to the Engine. This Will Work
 on the SuperTigre G-34 and S-29 (an old engine) engines. It is a 90° adapter.

INCLUDES: One Exhaust Adaptor - this adapts the aluminum pipe to the exhaust
            port on the side of the cylinder head on the engine.
          One Screw
          One Nut
          One Lock Washer to hold the exhaust adapter to the aluminum pipe
          One Muffler Gasket (SUPG4660)
          Two Mounting Screws - Used to mount the exhaust adapter to the
            crankcase.  These are 3x12mm screws.
          Two Lock Washers - used with the above mounting screws (3mm)
          One Bent Aluminum Pipe - this is the exhaust pipe or header pipe.

REQUIRES: Tuned Pipe.
          Silicone Coupler (goes in between the tuned pipe and the tuned pipe
            adapter), a 5/8" ID coupler is required

SPECS:    Inner Diameter of pipe: 15mm (.59")
          Outer Diameter of pipe  16mm (.63")
          Distance from Exhaust Port to Outside of Pipe (approx): 87mm (3.43")
          Distance from Inlet of Pipe to Outlet of Pipe (an approx fore/aft
            length): 180mm (7.1")
                                                                    JBN 4.12.93
                                                                          ir/jl



– If you need more information, use these SuperTigre resources –

E-mail: enginesupport@hobbico.com
Web Site: http://www.supertigre.com/
Phone: 217-398-8970


 
Postal Address:
SuperTigre
3002 N. APOLLO DRIVE, SUITE #1
CHAMPAIGN, IL 61822  








Click here for Units of Measure Conversion Calculators