This is the .26 Powerhouse Engine by Hot Bodies.
Fits HPI Savage .21, and the Hot Bodies Lightning series buggies
and popular .21 engined vehicles.
FEATURES: ABC construction
6-Port sleeve
Large Purple heat sink head
Round port rear exhaust
Pull-start
3 needle slide valve carb
SG (Pilot Shaft) style crankshaft
included
Brass collett included
INCLUDES: One .26 (4.26cc) sized engine with pull-start
Instruction sheet
REQUIRES: Air filter depending on vehicle
10%-30% Nitro Fuel with at least 18% lubricant
Most of the fuels we carry meet or exceed the lubricant content
required for optimum performance and maximum engine life. In the
past, the conventional lubricant content used in fuel was 18%. But
with new advanced technologies, fuels like Red Alert and O'Donnell
for example, have a better quality of lubricants even though the
percentages of lubricant content are lower. These high-tech
lubricants provide exceptional cooling and protection.
SPECS: Horsepower: 2.6HP @ 28,000 RPM
Distance between mounting holes same side: 0.83" (21mm)
Distance between mounting holes opposite side: 1.5" (38mm)
Distance from pull starter to end of crankshaft: 4.6mm (116mm)
Distance/center of crankcase to end of crankshaft: 3" (76mm)
Width between mounting ears: 1.8" (46mm)
Height/bottom of mounting ears to top of cylinder head: 3.8" (97.5mm)
Height/bottom of crankcase to top of cylinder head: 4.4" (112mm)
Factory Needle settings: High-Speed 3-1/2 turns
Low-Speed 3-1/2 turns
Midrange 3-1/4 turns
Temp range: 210°F-275°F
COMMENTS: Although this engine has 3.5cc printed on the side of the crankcase
its displacement is 4.26cc.
mcw 11/15/03
ir/jxs
Click here for Units of Measure Conversion Calculators
E-mail This Page To A Friend
Primary Accessories
Primary Accessories
