This is the Mega Nitor 2 Starter with Meter from Megatech.
FEATURES: Quick release plug lock design (spring loaded) for fast starts
Full charge lasts all day
Fits all glow plugs
Rechargeable hundreds of times
Charge level/ status gauge
Bonus Chris Chianelli Signature Series included (MTCG1692)
Plastic battery case and metal locking mechanism
INCLUDES: One glow igniter with pre-installed battery
One AC wall charger (170 mah charge rate) with 76" (1930mm) long lead
One bonus Chris Chianelli Signature Series (MTCG1692)
One rubber shaft cap
REQUIRES: Before using, the initial charge should be 14-16 hours. Subsequent
charging time is 12 hours.
SPECS: Length: 5.5" (140mm) total length
Shaft only length: 3" (76mm)
COMMENTS: Here is how to read the charge level/ status gauge:
Once ignitor is attached to the engine's , look at the red
and green gauge located on top of the ignitor. If the needle points
to the green area,the ignitor is charged and the is good.
If the needle points to the red area, either the ignitor needs to be
charged or the is not good. To test the glow plug,
unscrew the from the engine and attach to the ignitor in
the same manner as if it were on the engine. The bottom of the glow
plug will glow red. if it does not, you must replace the .
If it does glow red but your meter still reads in the red zone, the
ignitor needs to be recharged.
kpm02/24/2004
ir/jxs
– If you need more information, use these Megatech resources – |
E-mail: info@megatech.com
Web Site: http://www.megatech.com/
Phone: 201-662-8500
|
|
Postal Address:
Megatech
8300 TONNELLE AVE
NORTH BERGEN, NJ 07047
|
Click here for Units of Measure Conversion Calculators