This is the Castle Creations Phoenix-10 amp Sensorless ESC for Brushless motors
This speed control is specifically designed for Brushless application.
NOT to be used with Brushed motors. Doing so will ruin ESC.
FEATURES: Extremely low resistance (.013 Ohm)
High rate (11kHz) switching
Up to 10A continuous current with proper air flow, 15A surge
Five to eight cells with four micro
Up to ten cells with three micro
16 cells max with BEC disabled
Dynamic braking ensures folding props fold properly
BEC (1.5A) provides power to receiver and -eliminates need for
a separate receiver battery
User programmable features:
Low voltage cutoff
Auto- setting automatically sets 3V/cellfor 2-4 cell LiPo packs
Over-current protection
Brake type
range
Timing advance
Cutoff type
Soft start ramp up
Runs motor in forward or reverse
Auto motor in cutoff with reset
Safe power on arming program ensures motor won't accidentally turn ON
Low torque soft start prevents damage to fragile gearboxes
Auto Shut Down when signal is lost or radio interference becomes
severe
INCLUDES: Instruction sheets
Phoenix 10 ESC
REQUIRES: Soldering to motor and connector
Soldering iron HCAR0775
Solder WSDC4030
Battery connector (specific to customer's connectors)
SPECS: Length: 1" (25.4mm)
Width: 3/4" (19mm)
Height: 1/8" thick (3mm)
Wire Length: 4" (102mm) motor ends 5.5" (140mm) battery end
5.5" (140mm) servo wire with Universal connecter
COMMENTS: Be sure polarity is correct. Incorrect polarity can damage the
speed control unit.
dda 05/09/04
ir/jxs
Click here for Units of Measure Conversion Calculators