This is the Castle Creations Phoenix-35 amp Sensorless ESC for Brushless motors
This speed control is specifically designed for Brushless application.
NOT to be used with Brushed motors. Doing so will ruin ESC.
FEATURES: Extremely low resistance (.0035 Ohm)
High rate adjustable switching
Up to 35A continuous current with proper air flow, 45A surge
Five to ten cells with four micro
Up to twelve cells with three micro
16 cells max with BEC disabled
Dynamic braking ensures folding props fold properly
BEC (3A) provides power to receiver and -eliminates need for
a separate receiver battery
User programmable features:
Low voltage cutoff
Over-current protection
Brake type
range
Timing advance
Cutoff type
Soft start Ramp Up
Switching frequency
Runs motor in forward or reverse
Auto motor in cutoff with reset
Safe power on arming program ensures motor won't accidentally turn ON
Low torque soft start prevents damage to fragile gearboxes
Auto Shut Down when signal is lost or radio interference becomes
severe
INCLUDES: Instruction sheets
Phoenix 35 ESC
REQUIRES: Soldering to motor and connector
Soldering iron HCAR0775
Solder WSDC4030
Battery connector (specific to customer's connectors)
SPECS: Length: 1.75" (45mm)
Width: 1" (25.4mm)
Height: 3/8" thick (9.525mm)
Wire Length: 4" (102mm) motor ends 5.5" (140mm) battery end
11" servo wire w/Universal connecter
COMMENTS: Be sure to have correct polarity, incorrect polarity can damage the
speed control unit
dda 05/09/04
ir/jxs
Click here for Units of Measure Conversion Calculators