Tower Catalog Page:	59
E-mail This Page To A Friend

        This is the radio controlled, electric powered, foam constructed
            Multiplex Space Scooter Park Flyer Ready To Fly model.
                For Beginner to Intermediate Modeler/Fliers.
     Seek the help of an experienced flier if you are a beginning flier.

FEATURES: Wings:  One-piece Elapor foam
          Radio Compartment: Concealed behind motor
          Cowling: Front portion of fuselage is removed to expose radio
            compartment and motor assembly
          Canopy: Molded into fuselage, outlined with a decal from decal sheet.
          Servos: Pre-installed Multiplex Nano-S for the aileron and
            elevator (model does not have rudder control)
          HiTec Focus 3 SS FM transmitter with a Hitec HFS-04MG receiver
          Motor: Pre-installed Permax 400, gearbox and 10" diameter folding
            propeller
          Electronic Speed Controller: Pre-installed Multiplex X-08
          Battery: 7-cell NiCd flat pack with Tamiya style (AA size cells)
          Charger: DC with Tamiya style connector (egg timer style dial)
          No landing gear, model is to be hand launched and belly landed
          Hardware: All required hardware is included

INCLUDES: Foam wing and fuselage, hardware package, 400 motor, 3:1 gearbox,
           3 channel radio, Electronic Speed Control, charger, 7-cell battery,
           folding propeller, decal sheet, pre-installed Nano S servos, and
           instruction manual

REQUIRES: Eight AA batteries for the transmitter and a way to power the
           charger (can use a automobile battery or power supply)

SPECS:    Wingspan:       33.9" (862mm)
          Wing Area:     356 sq in (23 sq dm)
          Weight:         19.4oz (550g)
          Wing Loading:    7.86oz sq ft (24g/sq dm)
          Length:         31.1" (792mm)
          Airfoil:     Semi-Symmetrical
          Center of Gravity: 4.3" (110mm) back from the wing's leading edge
            at the fuselage sides.

COMMENTS: This model is NOT made of styrofoam and it is not possible to glue
            the material using white or epoxy glue. Medium CA glue used with an
            activator is the only method of gluing recommended by the
            manufacturer.

                                                                  kpm11/08/2004
                                                                         ir/jxs



– If you need more information, use these Multiplex resources –

Web Site: http://www.multiplexusa.com/
Phone: 858-748-6948


 
Postal Address:
Multiplex
12115 PAINE STREET
POWAY, CA 92064  








Click here for Units of Measure Conversion Calculators