Parts Express Eligible:	Yes
Tower Catalog Page:	182
E-mail This Page To A Friend

         The S136G Compact Landing Gear Retract Servos are extra-flat
                        so they will fit into a wing.

         This servo can produce high-current draw from your batteries.
         If using NiMH or Li-Po batteries, make sure they are capable
                        of delivering sufficient amps.

FEATURES: Two Ball Bearings
          Nylon Gear Set
          3-pole motor
          Compact Size
          Travels 180° - full-lock to full-lock -- to hold your gear in
            position securely. Not proportional. Perfect for mechanical
            retract installation. (see COMMENTS)
          One-Year Warranty

INCLUDES: One S136G Compact Retract Servo w/ J Connector

REQUIRES: If mounting hardware is needed, order Mounting Screws, FUTM2250
                                                Brass Eyelets, FUTM3650
                                                Grommets, FUTM2346

SPECS:    Length: 1.8"   (46mm)
          Width:  0.9"   (23mm)
          Height: 1.0"   (25mm)
          Torque: 61 oz-in (4.4 kg/cm) @ 4.8V
                  76 oz-in (5.5 kg/cm) @ 6V
          Speed: 0.60 sec/60° @ 4.8V
                 0.50 sec/60° @ 6.0V (it actually travels 180° see COMMENTS)
          Weight: 1.5oz (42g)

COMMENTS: A retract servo is a very specialized servo. It is non-proportional,
            going 180°, "lock to lock". It is specifically made for Mechanical
            Retracts to lock the gear in the up and down positions, and DOES
            NOT have any means of end point adjustment and cannot be adjusted
            by ATV on a transmitter. It is only able to go 180° and provide
            full maximum available torque at the two end points.
            This is its whole purpose and intentional design, but if someone
            has a unique design situation where they need other than 180°
            available, they must use a proportional servo, not a Retract Servo.
            Retract Servos are designed to withstand constant holding loads
            in the up and down positions, unique to the use of Mechanical
            Retracts.
            Pneumatic retracts do not need a retract servo. A proportional
            standard or mini servo is used to move the air valve back and forth

                                                                          ir/jl
                                                              updt jxs 10/30/03
                                                              updt jxs 10/29/04



– If you need more information, use these Futaba resources –

Click Here: Manufacturer's Product Web Page
E-mail: support@futaba-rc.com
Web Site: http://www.futaba-rc.com/
Phone: 217-398-8970


 
Postal Address:
Futaba
3002 N. APOLLO DRIVE, SUITE #1
CHAMPAIGN, IL 61822  








Click here for Units of Measure Conversion Calculators