View Larger Picture

Product Reviews:	Review 1
Instruction Manuals:	Manual 1 (3.2 MB)
Tower Catalog Page:	199
E-mail This Page To A Friend

        This is the O.S. Max 18TZ Turbo Engine with Pilot Shaft and
                   3 needle 11K Slide Valve Carburetor.
                      Ideal for on-road touring cars.

FEATURES: Oversize case fins dissipate heat to keep engine temperatures lower
          Five port cylinder liner for increased air flow
          12mm rear bearing lessens vibration and allows engine to handle more
           torque
          Slide valve, three needle 11K carburetor designed for on-road
           vehicles
          Super-hot turbo P3 glow plug for more power and improved fuel economy
          Rear exhaust, round port design
          Two-piece head design (inner head or head button and outer head)

INCLUDES: One 18TZ turbo engine with pilot shaft, 11K slide valve carburetor,
            P3 glow plug, exhaust seal o-ring and instruction manual

REQUIRES: Muffler (exhaust system) depending on vehicle
          Starting equipment
          Fuel: 5% - 20% nitromethane content
             Most of the fuels we carry meet or exceed the lubricant content
             required for maximum engine performance and long life. In the past
             conventional lubricant content used in fuel was 18%. But with new
             advanced technologies, fuels like Red Alert and O'Donnell have a
             better quality of lubricants even thought the percentages of
             lubricant content are lower. These high tech lubricants provide
             exceptional cooling and protection.

SPECS:    Displacement: 0.183 cu in (3.0cc)
          Bore: 0.629" (16.0mm)
          Stroke: 0.590" (15.0mm)
          Practical RPM: 3,000-34,000
          Output: 1.8ps @ 29,000 RPM
          Weight: 7.8oz (222g)

          Distance between mounting holes same side:             0.43" (11mm)
          Distance between mounting holes opposite side:         1.2" (31.4mm)
          Distance from end of crankshaft to front bearing:      1.16" (29.5mm)
          Distance from center of engine to front of crankcase:  1.4" (34.8mm)
          Distance/bottom of mounting flanges/top of cylinder head:3.2"(81.2mm)
          Width of mounting flanges:                             1.5" (39mm)
          Length of exhaust flange:                              0.24" (6mm)

          Needle Settings: High Speed: 2.5 turns out from fully closed
                           Metering Needle (low speed): flush with carb or ball
                                       link body
                           Throttle Stop Screw: 1mm open from fully closed

                                                                    kpm11/29/04
                                                                         ir/jxs
                                                               updt lmm 4/16/09



– If you need more information, use these O.S. resources –

Click Here: Manufacturer's Product Web Page
E-mail: enginesupport@hobbico.com
Web Site: http://www.osengines.com/
Phone: 217-398-8970


 
Postal Address:
O.S.
3002 N. APOLLO DRIVE, SUITE #1
CHAMPAIGN, IL 61822  








Click here for Units of Measure Conversion Calculators