This is the Great Planes Electric Powered, Radio Controlled
Almost Ready-to-Fly Siren T-Tail Airplane.
FEATURES: Construction: Carbon fiber for high strength and low weight,
motor mount and formers constructed of plywood
Wing: one piece, built-up, factory covered, carbon reinforced
Tail: built up T-tail design
Covering: Iron on polyester film
Motor Mount: pre-installed, wood construction
Radio Compartment: pre-installed, wood construction
Hardware: included
INCLUDES: Carbon fiber , main wing, tail section, servo covers
hardware package, decal sheet and instruction manual
REQUIRES: Radio: 3 channel minimum (, , )
: 3 micro or nano size with at least 16 oz-in torque
(two and one servo)
Servo extensions: three 24" extensions required - HCAM2200
: one required - HCAM2500
Electric Motor: T-601 Brushed motor (GPMG0706) or 480 geared
Brushless motor system (KONG5020)
Electronic Speed Control: 30A for Brushed motor or
40 amp for brushless (KONM3100) or with motor system (KONG5020)
Battery Brushed Motor: 7-8 cell 2000mAh (GPMP0351 or GPMP0352)
Battery Brushless Motor: 10-cell 2000mAh (GPMP0353)
Battery : See comments
Propeller Brushed Motor: 8x4 folding (GPMQ1650)
Propeller Brushless Motor: 13x7 folding (APCQ4357 and APCQ4390)
Spinner Brushed Motor: included with folding prop (GPMQ1650)
Spinner Brushless Motor: (GPMQ1651)
Building and Field Equipment:
SPECS: Wingspan: 79" (2005mm)
Length: 39" (980mm)
Wing Area: 430 sq in (27.7sq dm)
Weight Range: 2.25 - 2.5 lb (1020 - 1130 g)
: 12 - 13 oz (37 - 40 g/sq dm)
COMMENTS: In addition to batteries, Lithium batteries can be used to
power both power systems of the Siren ARF. Using Lithium batteries
will increase your flight times substantially while decreasing the
final weight of the model slightly. The following are the
recommended Lithium batteries for the Siren ARF.
Brushed Sport Package
This power system requires two 7.4V 1500 mAh batteries wired in
parallel for a 2S-2P configuration. Required for this is:
Two Great Planes Lithium-Polymer packs
Two W.S. Deans 2-Pin Ultra Plugs WSDM3001
One W.S. Deans Wet Noodle Flex Wire WSDC1410
Brushless Option One
This power system requires two 11.1V 1500mAh batteries
wired in parallel for a 3S-2P configuration. This configuration
will deliver slightly less performane than the 10-cell pack,
but the run time will be increased to 5-6 minutes. Required is:
Two Great Planes 1500mAh 11.1V 3-cell pack
Two W.S. Deans 2-Pin Ultra Plugs WSDM3001
One W.S. Deans Wet Noodle Wire WSDC1410
Brushless option 2
Four 7.4V 1500mAh batteries wired in series and parallel
for a 4S-2P configuration. This configuration will deliver the
highest performance and 4-5 minutes of run time. Required is:
Four Great Planes 1500mAh 7.4V 2-cell packs
Four W.S. Deans 2-Pin Ultra Plugs WSDM3001
One W.S. Deans Wet Noodle Flex Wire WSDC1410
kpm12/10/2004
Click here for Units of Measure Conversion Calculators