Put an end to recoil starter headaches and add one-hand starting ease by
installing the Kwik-Pit Super Start System from DuraTrax on your model.
This version will convert recoil equipped O.S. brand .12 to .21
and DuraTrax Torq .12-.16 engines.
**Does not fit on the O.S. 18TZ****
FEATURES: Easy one-hand starting means the end of blisters and broken recoil
ropes
Powerful twin 540 motors are powered by twin 6-cell sub-C stick
battery packs (not included) Unit will not operate on only one pack
Steel gear drive
Dust and impact resistant composite plastic case
Hinged access door provides for easy battery installation
ON/OFF rocker switch with safety side guards
Twin ball bearing-supported gear drive
Two clips on the unit's bottom for storage of starting shaft
INCLUDES: One Kwik-Pit Super Start power unit
One front and rear gear case - key number 23 (DTXP6059)
One 32 tooth steel, adapter gear - key number 16
One 11 tooth steel, small adapter gear - key number 12 (DTXP6045)
Four 2.6x10mm hex head screws - key number 25 (DTXQ0283) (requires a
2mm allen wrench for installation - DTXR0252)
REQUIRES: The stock engine back plate and one way bearing
Two 6-cell sub-C batteries and charger - DTXP4600 or modeler's choice
Installation following included instructions sheet
Starting Unit Starting Shaft
SPECS: Length: 10" (254mm) 7.25" (185mm)
Width: 2.1" (53mm) NA
Height: 4" (101mm)_ NA
Diameter: NA .21" (5.4mm)
COMMENTS: For the O.S. 18TZ, use coverplate (OSMG8984) and Kwik-Pit
plate (DTXP6026)
kpm12/29/2004
ir/jxs
Click here for Units of Measure Conversion Calculators