Instruction Manuals:	Manual 1 (335 KB)
Tower Catalog Page:	202
E-mail This Page To A Friend

                   This is the gasoline powered Fuji Imvac
                   1.5 cu inch (25cc) EIS 4-Stroke Engine.

FEATURES: New four-stroke design for more reliability and starting ease
          CNC machined parts
          Head up mounting only (no side or inverted mounting)
          EIS (Electronic Ignition System)
          Parts are lubricated by a constant flow of ultra-low-viscosity Fuji
            0W20 100% synthetic oil from a pan on the bottom of the engine
          Walbro butterfly-type carburetor, FJIG3290 fine tuning the Idle, Low
            and High Speed screws can be accomplished in a few seconds with
            only a slotted screwdriver
          Ball bearing-supported crankshaft
          True chrome plated cylinder
          Direct R/C specific throttle linkage setup
          Custom firewall mounting system
          Can be identified by the BF-25EI nameplate on the rotor
          No break-in required
          3-YEAR Warranty for US and Canada

INCLUDES: One Fuji Imvac 1.5 cu in (25cc) 4-stroke engine w/Champion RCJ6Y or
          NGK CMR6A spark plug FJIG7475, muffler FJIG6095, mounting hardware,
          30mm prop flange, 13x16mm box spanner FJIG3730, 4mm hex wrench,
          100cc fuel bottle, and instruction manual

REQUIRES: Regular unleaded gasoline, propeller, engine ON/OFF switch
          EIS battery    FJIP9925
          Fuji Super Lubricating Oil FJIP9910 or equivalent 0W-20 oil

SPECS:    Height: Oil Pan to Rocker Cover 7½" (190.5mm)
          Width: 6½" (165mm)
          Weight: 4.65 lbs (2,113 g) with muffler
                  4.23 lbs (1,919 g) without muffler
          Distance from firewall to prop rotor: 5-1/8" (130mm)
          Muffler exhaust outlet diameter: 9mm inner, 11mm outer
          Distance across mounting screws on motor mount: 95mm
          Distance top and bottom mounting screws:        75mm
          Displacement: 1.5 cu in (24.5cc)
          Bore/Stroke: 24mmx24mm
          Spinner Bolt: 3/8-16 threaded 13mm hex
          Practical RPM: 1400-9000
          Peak Horsepower: 1.6hp @ 7500 RPM
          Peak Torque: .14kgm @ 5,000 RPM
          Default carb settings: High Speed 1¾ to 2 turns OUT
                                 Low Speed    1-1/3 turns OUT
          Recommended Propeller: 18x6 (TOPQ5215)

COMMENTS: The replacement EI unit is FJIG1001
          The plug gap should be set to .024" (0.6mm)

     Fuji Imvac is NOT related to the original Fuji Engines sold by MECOA

                                                                    mcw 1/13/05
                                                                         ir/jxs



– If you need more information, use these Fuji Imvac resources –

Click Here: Manufacturer's Product Web Page
E-mail: enginesupport@hobbico.com
Web Site: http://www.fuji-imvac.com/
Phone: 217-398-8970


 
Postal Address:
Fuji Imvac
3002 N. APOLLO DRIVE, SUITE 1
CHAMPAIGN, IL 61822  








Click here for Units of Measure Conversion Calculators