Instruction Manuals:	Manual 1 (335 KB)
Tower Catalog Page:	202
E-mail This Page To A Friend

          This is the gasoline powered Fuji Imvac 2.1 cu inch (34cc)
                              EIS 4-Stroke Engine.

FEATURES: New Four-Stroke Design for more reliability and starting ease
          CNC machined parts
          Head up mounting only. (no side or inverted mounting)
          EIS (Electronic Ignition System)
          Parts are lubricated by a constant flow of ultra-low-viscosity Fuji
            0W20 100% synthetic oil from a pan on the bottom of the engine
          Walbro butterfly-type carburetor, fine tuning the Idle, Low, and High
            Speed screws can be accomplished in a few seconds with only a
            slotted screwdriver (FJIG3290)
          Ball bearing-supported crankshaft
          True chrome-plated cylinder
          Direct R/C specific throttle linkage setup
          Custom firewall mounting system
          Can be identified by the BF-34EI nameplate on the Rotor
          No break-in required
          3-YEAR limited warranty for US and Canada

INCLUDES: One Fuji Imvac 2.1 cu in (34cc) 4-stroke engine with Champion RCJ6Y
            or NGK CMR6A Spark plug FJIG7475, muffler FJIG6095, mounting
            hardware, 30mm prop flange, M13x16 box spanner FJIG3730, 4mm hex
            wrench, 100cc fuel bottle, and instruction manual

REQUIRES: Regular unleaded gasoline, propeller, engine ON/OFF switch
          EIS battery    FJIP9925
          Fuji Super Lubricating Oil FJIP9910 or equivalent 0W-20 oil

SPECS:    Height: Oil Pan to Rocker Cover 8" (203mm)
          Width: 6¾" (171mm)
          Weight: 5.89 lbs (2,674 g) with muffler
                  5.46 lbs (2,477 g) without muffler
          Distance from firewall to prop rotor: 6" (152mm)
          Muffler exhaust outlet diameter: 9mm inner, 11mm outer
          Distance across mounting screws on motor mount: 95mm
          Distance top and bottom mounting screws:        75mm
          Displacement: 2.1 cu in (34cc)
          Bore/Stroke: 39x28mm
          Spinner Bolt: 3/8-16 threaded 13mm hex
          Practical RPM: 1000-7500
          Brake Horsepower: 2hp @ 7500 RPM
          Peak Torque: .20kgm @ 5,000 RPM
          Default carb settings: High Speed 1¾ to 2 turns OUT
                                 Low Speed    1-1/3 turns OUT
          Recommended Propeller: 22x6-10 (TOPQ5241)

COMMENTS:
          The replacement EI unit is FJIG1001
          The plug gap should be set to .024" (0.6mm)
          Fuji Imvac is NOT related to the original Fuji Engines sold by MECOA.
          If replacement oil is needed, 0w20 oil is readily available through
          a motorcycle parts supplier.
                                                                    mcw 1/13/05
                                                                         ir/jxs



– If you need more information, use these Fuji Imvac resources –

Click Here: Manufacturer's Product Web Page
E-mail: enginesupport@hobbico.com
Web Site: http://www.fuji-imvac.com/
Phone: 217-398-8970


 
Postal Address:
Fuji Imvac
3002 N. APOLLO DRIVE, SUITE 1
CHAMPAIGN, IL 61822  








Click here for Units of Measure Conversion Calculators