Parts Express Eligible:	Yes
Tower Catalog Page:	223
E-mail This Page To A Friend

        This is the Groove Tube-Grove Cutting Tool from Great Planes.

           This tool cuts perfect grooves in balsa for installing
           elevator joiner wires, aileron torque rods and bearings,
       tailgear wires and bearings, or to clean pushrod exits in fuselages.

FEATURES: Creates crisp, clean grooves in balsa by using a back and forth
            twisting motion.
          Creates a uniformly round groove that increases the rod's
            performance - without the need for sanding.
          Much safer than using a hobby knife or drill to gouge out the wood.

INCLUDES: One Groove Tube Cutting Tool (in a storage tube, mounted on a
            photo illustrated header card with useage instructions.

SPECS:    Groove Cutting Tube   Length: 4"     (112mm)
                              Diameter: 1/8"   (3mm)
          Plunger Rod           Length: 5-1/8" (131mm)
          Plunger Spring        Length: 1-1/2" (40mm)

COMMENTS: Caution: Always grasp the part behind the sharp edge of the cutting
            tube, and cut away from your body.
          For hard balsa, make two or three shallow cuts rather than one deep
            one.
                                                                     JAL 2/4/99
                                                                          ir/jl



– If you need more information, use these Great Planes resources –

Click Here: Manufacturer's Product Web Page
E-mail: airsupport@greatplanes.com
Web Site: http://www.greatplanes.com/
Phone: 217-398-8970


 
Postal Address:
Great Planes
3002 N. APOLLO DRIVE, SUITE #1
CHAMPAIGN, IL 61822  








Click here for Units of Measure Conversion Calculators