E-mail This Page To A Friend

This is the Castle Creations Phoenix-125A Sensorless ESC for Brushless motors
    This speed control is specifically designed for Brushless application.
         NOT to be used with Brushed motors. Doing so will ruin ESC.

FEATURES: Extremely low resistance (.0006 Ohm)
          High rate adjustable switching
          Up to 125A continuous current with proper air flow, 160A surge
          Five to ten cells with four micro servos
          Up to 12 cells with three micro servos
          20 cells max with BEC disabled
          Dynamic braking ensures folding props fold properly
          BEC (3A) provides power to receiver and servos-eliminates need for
            a separate receiver battery
          User programmable features:
            Low voltage cutoff
            Over-current protection
            Brake type
            Throttle range
            Timing advance
            Cutoff type
            Soft start Ramp Up
            Switching frequency
         Runs motor in forward or reverse
         Auto motor in cutoff with reset
         Safe "Power On" arming program ensures motor will not accidentally
            turn ON
         Low torque soft start prevents damage to fragile gearboxes
         Auto Shut Down when signal is lost or radio interference becomes
            severe

INCLUDES: Instruction sheets
          Phoenix 125 ESC
          2-1/2"x2-1/2" decal

REQUIRES: Soldering to motor and connector
          Soldering iron  HCAR0775
          Solder  WSDC4030
          Battery connector (specific to customer's connectors)

SPECS:    Length: 1.75"   (45mm)
          Width:     1" (25.4mm)
          Height:  3/8" thick (10mm)
          Wire Length: 4" (102mm) motor ends     5.5" (140mm) battery end
                      11" servo wire w/Universal connecter

COMMENTS: Be sure to observe correct polarity. Incorrect polarity can damage
           speed control unit.

                                                                     MCW 7/7/05
                                                                         ir/jxs



– If you need more information, use these Castle Creations resources –

E-mail: support@castlecreations.com
Web Site: http://www.castlecreations.com/
Phone: 913-390-6939


 
Postal Address:
Castle Creations
235 S KANSAS AVE
OLATHE, KS 66061  








Click here for Units of Measure Conversion Calculators