This is the Tekin Mini Rage Electronic Speed Control
for 1/18 scale vehicles.
FEATURES: ESC
On-board programming
Adjustable drag brake and reverse brake strength
Programmable Reverse lockout and low voltage cutoff
Adjustable and Brake profiles (2 modes with 7 profiles each)
Pre-installed Futaba J plug (JR and KO plugs also included)
Pre-Installed ON/OFF switch
Motor
Three wire design with pre-installed 3.5mm bullet connectors
Ball bearing-supported
Sensorless and brushless 5.4kV with high performance bearings
INCLUDES: Tekin Mini Rage Speed Control - TEKM1100
Three 3" long leads with 3.5mm female bullet connectors installed
Two 3.5" long leads (no connector, one black and one red wire)
Four 1x1" pieces of double sided tape
Two 2.5x5mm hex head motor mounting screws (requires 2mm hex wrench)
Two black plastic radio connectors (JR and KO)
Three sheets of Tekin logo decals (various colors included)
REQUIRES: Installation following the included intructions sheet, battery
connectors of modeler's choice, soldering iron and solder
SPECS: ESC
Length: 1.72" (44mm)
Width: 0.95" (24mm)
Height: 0.4" (10mm)
Weight: 0.9oz (24.5g)
Power: 25A
Surge: 60A
Resistance: 0.0045
Input power (except 8kV motor): 4-12 cells / or 2-4 cell
Input power (8kV motor): 4-8 cell / or 2-3 cell
Power Wires: 16AWG silicone
COMMENTS: Designed to work with the following Tekin motors - TEKC1201
and TEKC1202
jxs 6/28/05
update
kpm10/31/2005
ir/jxs
Click here for Units of Measure Conversion Calculators