View Larger Picture

On-line Videos:	Video 1
Tower Catalog Page:	102
E-mail This Page To A Friend

     This is the 1/8 scale glow powered, radio controlled, Ready To Run
                       HPI Hellfire off-road Monster Truck.

FEATURES: Chassis: .12" (3mm) thick Gunmetal colored aluminum construction
            with Black anodized aluminum upper deck
          Drive: Four wheel shaft drive
          Radio: HPI TF-3 pistol grip with high torque SF-2 steering servo and
           standard torque SF-1 throttle servo/brake servo (made by Airtronics)
          Receiver Battery: 1100mAh 5-cell NiMH receiver battery and 2-hour
            (300mAh) wall charger
          Engine: HPI Nitro Star K4.6 HO pull start with glow plug, fuel filter
           and high flow 2-stage air filter (.28 cu in)
          Exhaust: Gunmetal colored anodized aluminum tuned pipe with header
          Fuel Tank: 5.1oz (150cc), with flip top cap and splash guard
          Clutch: Three shoe
          Transmission: Single speed
          Ball Bearings: Full set included
          Shocks: Four oil-filled, with coil-over spring, aluminum bodied with
            3.5mm Titanium Nitride coated shafts for durability and maximum
            performance, 24 possible mounting positions to fine tune suspension
            The shocks are filled with 200 weight shock oil
          Main Gear: 52 tooth steel construction
          Clutch Bell: 13 tooth steel construction
          Gearbox: Sealed front and rear
          Differentials: Bevel gear type
          Brakes: Vented steel disk
          Tires: HPI Aggressor racing tread with foam inserts - HPIC4892
          Wheels: Black 1-piece, aero dish - HPIC1513
          Wheel Hubs: 17mm hex style retained with pin and grub screw
          Body: Pre-trimmed and painted DRX truck body with applied decals
          Bumpers: Black nylon front and rear
          Suspension: Adjustable kick up, anti-dive and anti-squat front and
            rear anti-roll bars, no e-Clips used on major suspension components
          Caster: Adjustable with urethane eccentric bushings
          Camber: Adjustable front and rear
          Steering Tie Rods: Adjustable
          Steering: Bellcrank with spring-loaded servo-saver
          Sway bar: Front and rear factory installed
          Warranty Period: 2 years from date of purchase

INCLUDES: Factory assembled Hellfire model with engine and tuned pipe. Factory
           painted body, 2 channel AM 27MHz pistol grip radio with hi-torque
           steering servo and 5-cell NiMH receiver battery.

REQUIRES: Radio Batteries: (8) AA size - EVEP1205
          Glow starter: DTXP3000
          Misc. Items:  building and track equipment
          Fuel: 2-stroke glow fuel with 10%-15% nitromethane, 16% lubricant-
            Most of the fuels we carry meet or exceed the lubricant content
            required for optimum performance and maximum engine life. In the
            past, the conventional lubricant content used in fuel was 18%. But
            with new advanced technologies, fuels like Red Alert and O'Donnell
            for example, have a better quality of lubricants even though the
            percentages of lubricant content are lower. These high-tech
            lubricants provide exceptional cooling and protection.

SPECS:      Vehicle-
          Length:          20.1" (513mm)
          Width:           16.3" (415mm)
          Height:           6.8" (173mm)
          Weight:           9.2lbs (4173g) RTR, less fuel
          Wheelbase:       13.7" (348mm) varies with inboard toe setting
          Tread: Front and Rear: 13.25" (336mm) (wheels on-center side-to-side)
          Front Track: 16.25" (412mm)
          Rear Track:  16.25" (412mm)
          Ground Clearance: 2" (51mm)
          Tires- Front and Rear - Diameter: 5.47" (139mm) outside
                                  Diameter: 3.26"  (83mm) inside
                                  Width:    2.91"  (74mm)
            Body-
          Length:  18" (457mm)
          Width: 7.25" (184mm)
          Height: 4.5" (114mm)

COMMENTS: For Replacement Ball Bearings use:
            Qty.  Size      Location                      Bearing Set Qty.
             2   5x10mm   Clutch Bell                       DTXC1535   2
             4   8x16mm   Front and Rear Diffs              DTXC1585   2
             4   8x16mm   Front and Rear Gearbox            DTXC1585   2
             2   8x16mm   Center Diff                       DTXC1585   1
             4   8x16mm   Front Knuckle Arms                DTXC1585   2
             4   8x16mm   Rear Hub Carriers                 DTXC1585   2
             4   6x10mm   Bellcrank                         DTXC1561   2

          Body pictured on the box is painted Red with Black and Gray decals
            applied.
          The shocks are filled with #200Wt shock oil in the front and rear
          The radio channel cannot be choosen as the models are supplied at
           random by HPI

         For an optional budget engine from O.S. Max, the .21 VG-P (OSMG2058)
           can be used. The O.S. Max .21 VZ-B V-Spec-T (P) (OSMG2068) is a good
           choice for a high performance engine. Both engines require a Tuned
           Pipe (OSMG2938).

                                                                    jxs 9/12/05
                                                                  kpm01/26/2006
                                                                         ir/jxs



– If you need more information, use these HPI Racing resources –

E-mail: support@hpiracing.com
Web Site: http://www.hpiracing.com/
Phone: 949-753-1099


 
Postal Address:
HPI Racing
70 ICON STREET
FOOTHILL RANCH, CA 92610  








Click here for Units of Measure Conversion Calculators