This is a Long Tuned Pipe Adaptor (Exhaust Manifold or Header) That is
Used to Adapt a Tuned Pipe to a Side Exhaust Engine.
Long refers to the distance between the engine and the bend in the header,
not the overall length of the header.
FEATURES: Made of Metal Tubing That Turns 90 Degrees Outward and Towards the
Rear of the Engine.
At the Output End of this Adaptor the Silicone Coupler Slides On and
is Secured by One Tie-Wrap (Included).
The Tuned Pipe (Not Included), Then Fits Into the Silicone Tubing and
is Secured by One Tie-Wrap (Included).
The Pipe is "Tuned" by Shortening or Lengthening the Distance of the
Tuned Pipe Where It Fits Into the Silicone Coupler Until the
Engine Reaches Maximum Power and RPMs.
If Maximum RPMs Cannot be Reached Within the Silicone Tubing,
Cut Off Output End of Adapter in 1/4" Segments Until No Further
Increase or a Drop in Speed is Noted.
INCLUDES: .91FX Long Tuned Pipe Adapter
Gray Silicone Coupler
Two White Nylon Tie-Wraps
Two Mounting Screws 1-15/16" (43mm) (Original Screw Is 4 x 40mm)
Two Lock Washers
SPECS: Overall Length: 9-1/4" (235mm)
Inner Diameter: 3/4" (19.2mm)
Outer Diameter: 7/8" (22mm)
Exhaust Port to Center-Line of Header: 2-3/8" (60mm)
Mounting Screws Center-to-Center: 1.646" (41.6mm)
Exhaust port: 9.0 x 29.5 mm rectangular
Distance between mounting holes: 42mm
REQUIRES: Tuned Pipe, use MACG1190.
COMMENTS: For Standard Tuned Pipe Adapter, use MACG2980.
MAF2/19/99
ir/jl
updated mcw 8/19/03
updt mcw 5/29/04
– If you need more information, use these Macs resources – |
Web Site: http://www.macspro.com/
Phone: 916-456-6932
|
|
Postal Address:
Macs
7935-A CARLTON ROAD
SACRAMENTO, CA 95826
|
Click here for Units of Measure Conversion Calculators
Yes
E-mail This Page To A Friend
