This is the 1/8 scale glow powered, radio controlled,
Ofna Jammin' X1X-CR Pro Off-Road Buggy Kit.
This Jammin' X1X-CR Pro has the following upgrades
from the original version;
Pro Shocks w/ 13mm Bodies Fiberglass Disc Brake
CNC Front B Block Special Arm Pin Set
CNC Shock Towers 5mm Shock Towers
Captured Hinge Pins
FEATURES: Chassis: 0.12" (3mm) CNC countersunk aluminum with 0.20" (5mm) thick
shock towers
Drive: Four wheel, shaft driven
Fuel Tank: 4.2oz (125cc) w/flip top cap
Clutch: Aluminum 3-shoe clutch
Transmission: Single Speed
Ball Bearings: Full set
Shocks: Four Pro threaded with 13mm diameter hard anodized aluminum
bodies
Main Gear: 48T steel
Gearbox: Sealed both front and rear
Differentials: Planetary geared front and rear
Brake: Fiberglass disk
Body: Clear buggy
Tires: Jammin' Ripper square spike tires with foam inserts 2.6"
(66mm) inner diameter, 1.6" (40mm) wide
Wheels: 2.6" (66mm) diameter plastic dish wheels, neon yellow in
color
Bumpers: Front high strength nylon
Caster: Adjustable, caster/toe-in refers to the angle of the front
suspension when viewed from the side of the car in relation to the
chassis
Camber: Adjustable, camber refers to the angle of the tops of the
tires from vertical when viewed from front or behind vehicle
Steering: Bell crank type w/servo saver
INCLUDES: Jammin' X1X-CR Pro rolling chassis w/shocks, lexan body
tires, wheels, foam inserts, 48T steel spur gear, aluminum engine
mount, medium fuel tubing, foam air filter, instruction manual
molded neon yellow rear wing, stickers, window mask sheet
REQUIRES: Radio: 2-Channel with 2 standard size
(high torque servo for steering recommended but not required)
Radio Batteries: (8) AA size
Engine: .21 w/rear exhaust and pilot shaft
Tuned Pipe and Manifold for Rear Exhaust
Glow Starter: 1.2 volt
Paint: Polycarbonate for body
Misc. Items: Fuel bottle, building and track equipment
Fuel: 2-cycle glow fuel with 10%-15% , 16% lubricant-
Most of the fuels we carry meet or exceed the lubricant content
required for optimum performance and maximum engine life. In the
past, the conventional lubricant content used in fuel was 18%. But
with new advanced technologies, fuels like Red Alert and O'Donnell
for example, have a better quality of lubricants even though the
percentages of lubricant content are lower. These high-tech
lubricants provide exceptional cooling and protection.
SPECS: Vehicle-
Length: 15.75" (400mm)
Width: 8" (203mm)
Height: 5.25" (133)
Weight:
Wheelbase: 13.1" (332mm) (wheels on-center front-to-rear)
Tread- Front- 10.25" (260mm) Rear- 10.25" (260mm)
Front Track: 12" (304mm)
Rear Track: 12" (304mm)
Ground Clearance: 1.25" (31.75mm)
Gear Ratio: Not listed
Tires- Front and rear: Width: 1.6" (40mm)
Outer Diameter: 4.3" (110mm)
Inner Diameter: 3.1" (80mm)
Wheels: Width: 1.6" (40mm)
Diameter: 3.1" (80mm)
Body- Wing-
Length: 14-1/2" (368mm) Width: 8-5/8" (211mm)
Width: 8-1/2" (216mm) Height: 2-3/8" (61mm) at sides
Height: 3-3/4" (95mm)
COMMENTS: For Replacement Ball Bearings use:
Qty. Size Location Bearing Set Qty.
6 8x16mm Front, Rear & Center Diffs DTXC1585 - 3
4 8x16mm Front and Rear gear boxes DTXC1585 - 3
2 8x16mm Front Knuckles DTXC1585 - 1
2 8x16mm Rear Hubs DTXC1585 - 1
2 5x10mm Clutch Bell DTXC1535 - 1
To replace the bushings in the bellcrank setup, order these
bearings two 4x8mm flanged bearings (DTXC1517) 1 package and
four 6x10mm bearings (DTXC1561) 2 packages.
X1 radio bag listed on box is not included.
jxs 03/06/06
ir/jxs
– If you need more information, use these Ofna resources – |
E-mail: help@ofna.com
Web Site: http://www.ofna.com/
Phone: 949-586-2910
|
|
Postal Address:
Ofna
7 VANDERBILT
IRVINE, CA 92618
|
Click here for Units of Measure Conversion Calculators
| 
E-mail This Page To A Friend
Primary Accessories
Primary Accessories
