E-mail This Page To A Friend

              This is the HPI K4.6 High Output Pull Start Engine
                       for the HPI Hellfire, HPIC1050.

FEATURES: Composite body slide valve carburetor
          High flow 2-stage foam air filter
          Rear exhaust
          Two year limited warranty

INCLUDES: HPI K4.6 High Output Pull Start Engine with air filter assembly,
            cold R5 glow plug (HPIG1504), rubber exhaust gasket and instruction
            manual

REQUIRES: Fuel: Car blend with 20-25% nitro content
          Track Equipment: Glow starter, fuel tubing

SPECS:    Displacement: 0.28 cu in (4.59cc)
          Bore: 18.6mm
          Stroke: 16.9mm
          Practical RPM: 3,100 - 39,500
          Maximum Horsepower: 2.95 hp @ 38,000 rpm
          Maximum RPM: 41,000
          Carburetor Bore: 9.0mm with 8.0mm and 8.5mm reducer

          Distance Between Mounting Holes Same Side: 0.83" (21mm)
          Distance Between Mounting Holes Opposite Side: 1.5" (38mm)
          Height Bottom of Mounting Tabs to Top of Cylinder Head: 3.8" (97mm)
          Width at Mounting Tabs: 1.8" (45mm)
          Width of Crankcase Below Mounting Tabs: 1.2" (39mm)
          Distance from Front Bearing to End of Crankshaft: 1.2" (30mm)
          Distance from Pull Start to Front Bearing: 3.4" (83.1mm)
          Distance from Center of Engine to Front Bearing: 1.7" (44mm)
          Distance from Center of Engine to Pull Start: 1.5" (38mm)

                                                                    jxs 4/20/06
                                                                         ir/jxs



– If you need more information, use these HPI Racing resources –

E-mail: support@hpiracing.com
Web Site: http://www.hpiracing.com/
Phone: 949-753-1099


 
Postal Address:
HPI Racing
70 ICON STREET
FOOTHILL RANCH, CA 92610  








Click here for Units of Measure Conversion Calculators