This is a set of Robart 85 Degree Mechanical Main Retracts w/ 3/16" wire.
For .45-1.20 size gas powered models weighing 6-14 lbs.
FEATURES: Positive up and down locks
Tough glass-filled nylon construction
Light weight-5oz pair
3/16" Tempered steel gear legs
Mechanically operated with standard or "Retract"
INCLUDES: Two main 85 degree retracts
Eight mounting screws
Installation instructions and spare parts list
REQUIRES: Mounting to aircraft
2-56 threaded pushrod for operation
Approximately 1-1/8" of travel to operate retract from lock to lock
Possible cutting and bending of wire to proper length
SPECS: Total Length: 11-1/4" ( 286mm) closed, 11-1/8"(283mm) open
Width of base: 1-3/4" (44.45mm) x 1-3/4" (44.45mm)
On same side of retract, holes are 1-1/4" (31.75mm) center to center
Opposite side holes center to center: 1-11/32" (34.29mm)
Distance from edge of base to loop in closed position: 9/32" (8mm)
Distance from edge of base to loop in open position: 5/8"(16mm)
Diameter of loop: 21/32"(17mm)
Length of wire from loop: 8-1/2" (216mm)
Total height of base: 1-3/32" (27.94mm)
Thickness of mount lip: 3/32" (2.54mm)
Length of mount lip: 1-3/4" (44.45)
Width of base: 15/16" (24.13mm)
Height from bottom of base to center of control rod: 13/16" (21mm)
COMMENTS: This retract operates with a 2-56 threaded pushrod. The pushrod
screws into the control arm and will push or pull the control arm
to operate the system.
rda04/12/06
ir/jxs
– If you need more information, use these Robart resources – |
E-mail: robart@robart.com
Web Site: http://www.robart.com/
Phone: 630-584-7616
|
|
Postal Address:
Robart
625 N. 12TH STREET
ST. CHARLES, IL 60174
|
Click here for Units of Measure Conversion Calculators
Yes
E-mail This Page To A Friend
